Dacor Epicure EH30 Installation Instructions Manual
  1. Manuals
  2. Brands
  3. Dacor Manuals
  4. Ventilation Hood
  5. EPICURE EH30
  6. Installation instructions manual

Dacor Epicure EH30 Installation Instructions Manual

Epicure and millenia wall mount range hoods
Hide thumbs Also See for Epicure EH30:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Use and Care Manual
Epicure®and
Wall Mount
Installation
Millennia ®
Range Hoods
For use with models:
EH30, EH36, EH42, EH48, EH54,
MH30, MH36 and MH48
Instructions
APPROVED
FOR USE WITH ALL DACOR ® RANGES
AND COOKTOPS.
TESTED
IN ACCORDANCE
WITH THE LATEST
EDITION
OF ANSI/UL
507
STANDARD
FOR ELECTRIC
FANS AND CAN/CSA-C22.2
NO. 113 STANDARD
FOR FANS AND VENTILATORS.
Part No. 102139
Rev. d

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Epicure EH30 and is the answer not in the manual?

Questions and answers

Related Manuals for Dacor Epicure EH30

Summary of Contents for Dacor Epicure EH30

  • Page 1 Millennia ® Epicure®and Wall Mount Range Hoods For use with models: EH30, EH36, EH42, EH48, EH54, MH30, MH36 and MH48 APPROVED FOR USE WITH ALL DACOR ® RANGES AND COOKTOPS. TESTED IN ACCORDANCE WITH THE LATEST EDITION OF ANSI/UL STANDARD FOR ELECTRIC FANS AND CAN/CSA-C22.2...
  • Page 2 Keep these installation instructions for future reference and the local electrical inspector's use. If You Need Help... If you have questions or problems with installation, contact your Dacor dealer or the Dacor Customer Service Team. For repairs to Dacor appliances under war- ranty call the Dacor Distinctive Service line.
  • Page 3 WARNING ating this or any other appliance. Hazards 0r Unsafe practices that COULD result in severe • Always contact the Dacor Customer Service Team personal injury or death. about problems and conditions that you don't under- stand. CAUTION...
  • Page 4 The customer should not install repair or replace any part of the range hood unless specifically recommended the literature accompanying it. A qualified service techn c an should perform all other serv ce. Contact the nearest Dacor authorized service representative at (800) 793-0093, or at www.Dacor.com for examination, repair or adjust- ment •...

  • Page 5: General Specifications

    EH4812, MH4812 70 Ibs. (32 kg) Model Specific EH4818, MH4818 77 Ibs. (35 kg) Model Number EH5418 84 Ibs. (38 kg) EH48, MH48 EH42 EH30, MH30 EH54 EH36, MH36 Lights Filters Exhaust Outputs Fan Rating 1200 CFM 600 CFM 600 CFM...
  • Page 6 Dimensions Tolerances: +1/16",-0 (1.6 mm,-0), unless otherwise stated. NOTE: The exhaust duct(s) and electrical wiring can be connected from either the top or the back of the hood. Dual exhaust models* Single exhaust models** Standard 8" duct connection Standard 8" duct connection Front of hood Electrical access holes...

  • Page 7: Parts List

    2 temporary mounting brackets Temporary mounting hardware Hood assembly with filters (size and style varies with model) Blower mounting hardware (used only for installations requiring rear exhaust configuration Light replacement tool Literature Light bulbs (quantity varies with model) Dacor Stainless Steel Cleaner _mCD_...
  • Page 8 WARNING for I observe all g0verning c0des and ordinances during planning and installationl Contact y0ur local building department further informati0nl Cabinet Layout IMPORTANT See the diagram for minimum installed distance from WARNING the hood t0 the co0ktop surfacel The minimum specified distance maybe higher for the particular range or To reduce the risk of personal injury caused by reaching cooktop in use: Check the manufacturers...
  • Page 9 • On dual exhaust models, the two 8" exhausts may be WARNING merged into one 10" duct using Dacor transition kit AHT10. See page 16 for details. • To prevent combustion by-products, smoke or odors from entering the home and to improve efficiency,...

  • Page 10: Duct Cutout

    Electrical Service Installation Verify the Package Contents Unpack the parts box and verify that all parts have been included according to the parts list on page 5. If any item is missing or damaged, please contact the dealer immedi- The electric service to the rang e h00d Sh0U nst a ed WARNING ately.
  • Page 11 Ceiling or Back wall cabinet bottom Duct Cut-Out for Top Venting Duct Cut-Out for Rear Venting Blower Rotation Instructions WARNING SEE PAGE MODEL Do not install the range hood unless the electrical service provided meets the range hood specifica- EH3012, MH3012, EH3612, MH3612, tions.
  • Page 12 Disconnect the wiring harness connector from the Rotating the Blower for Models: blower motor. EH3012, MH3012, EH3612, MH3612 While supporting the blower from below, remove the four (4) nuts that hold the blower and mounting plate in EH4212 (Models that are 12 inches high place.
  • Page 13 13. Insert the opening on the blower motor assembly into 17. Tip the hood back down so that the top of the hood the hole inside the back of the hood. The connector faces up. Using existing screws, attach the cover plate on the motor must be toward the bottom of the hood.
  • Page 14 Remove and discard Tip the hood back, so that it lays on its back with the Remove front pointing up. the mounting plates and discard _._ attached to both blow- Remove the filters from the under side of the hood. er motors.
  • Page 15 14. Route the wiring harness as shown below. Secure Rotating the Blower for Models: the harness to the motor assemblies using the cable clamps supplied with the hood in the positions shown. EH3018, MH3018, EH3618, MH3618, EH4218 15. Attach the wiring harness to the brace inside the hood, (Models that are 18 inches high equipped with on the right side using two (2) supplied cable ties.
  • Page 16 Disconnect the wiring harness connector from the Route the wiring harness as shown. Secure the har- blower motor. ness to the motor assembly with the cable clamps sup- plied with the hood in the positions shown below. While supporting the blower from below, remove the four (4) nuts that hold the blower in place.
  • Page 17 Disconnect both wiring harness connectors from the Rotating the Blower for Models: blower motors. While supporting each blower from below, remove the EH4818, MH4818 and EH5418 (Models that are four (4) nuts that hold each blower in place. Remove 18 inches high equipped with two blowers.
  • Page 18 On dual exhaust models, the two 8" exhausts may be 12. Attach the wiring harness to the brace inside the hood, merged into one 10" duct using Dacor transition kit AHT10. on the right side using two (2) supplied cable ties.

  • Page 19: Mounting Bracket Installation

    12" high models with rear exhaust: Find the temporary mounting bracket in the shipping box. Put the bracket against the wall and line up the Center the transition over the duct collars while resting the center hole with the intersection of the bracket center unmodified edge on the top of the hood.

  • Page 20: Hanging The Range Hood

    Duct Work Installation Hanging the Range Hood WARNING WARNING During duct installati0n; make sure there are n0 Hanging the range hood requires _o peoplel Do not obstructions that kee p the damper flaps on the top of the attempt to lift the hood Without assistance: hood from open ng.

  • Page 21: Final Electrical Installation

    Final Electrical Installation WARNING • To avoid electric shock or fire hazard, prior to connecting the electrical wiring to the hood, make sure that power to the hood power supply line is turned off at the fuse box or circuit breaker panel. •...
  • Page 22 WARNING Water lines that are insulated must be jumped to assure continuity to groundl See below. To house circuit breaker Separate No. 10 (minimum) panel or fuse box copper ground wire Wire nut, Meter 3 places WHITE No. 4 copper GREEN wire Clamps...

  • Page 23: Installation Checklist

    Check the electrical connections to ensure that the installation has been completed correctly. Repeat the above test. If the hood still does not work, contact Dacor Distinctive Service at (877) 337-3226. Do not attempt to repair the appliance yourself. If you need service, be sure to have the model and serial numbers available when you call.
  • Page 24 HOOD LIGHTS 75W, 120V EACH O LL[ J,J, • • 11P2 1098765432 HOOD POWER AND POWER CONTROL BOARD SWITCH BLOWER MICROPROCESSOR 455W, 115V PROGRAMMING HEADER 2 4681o 1357 11 10987654321 CHASSIS WIRE COLOR CODE GROUND ¥ WHITE B - BLUE Y - YELLOW O - ORANGE R- RED...
  • Page 25 HOOD LIGHT HOOD LIGHT HOOD LIGHT 75V!, 120V 75W, 120V 75W, 120V _OBB 1wlw 11098765432 lIP2 HOOD POWER AND POWER CONTROL BOARD SWITCH BLOWER BLOWER MICROPROCESSOR 455W, 115V 455W, 115V PROGRAMMING HEADER 246810 1357 10987654321 CHASSIS WIRE COLOR CODE GROUND WHITE B - BLUE Y - YELLOW...
  • Page 26 24 c_acar...
  • Page 27 ® Family Owned American Made The Life of the Kitchen? Dacor • 600 Anton Blvd. Suite 1000 Costa Mesa, CA 92626 • Phone: (800) 793-0093 • Fax: (626)403-3130 • www.Dacor.com...

This manual is also suitable for:

Epicure eh36Epicure eh48Epicure eh54Mh30Mh36Mh48 ... Show all

Table of Contents