Download
Share
Print this page
CITROEN C5 2000 Handbook
  1. Manuals
  2. Brands
  3. CITROEN Manuals
  4. Automobile
  5. C5 2000
  6. Handbook
CITROEN C5 2000 Handbook

CITROEN C5 2000 Handbook

Specifications, adjustments, checks and special features
Hide thumbs

Advertisement

Quick Links

Download this manual
2000
«The technical information contained in this document is intended for the exclusive use of the trained personnel of the
motor vehicle repair trade. In some instances, this information could concern the security and safety of the vehicle. The
information is to be used by the professional vehicle repairers for whom it is intended and they alone would assume full
responsibility to the exclusion of that of the manufacturer».
''The technical information appearing in this brochure is subject to updating as the characteristics of each
model in the range evolve. Motor vehicle repairers are invited to contact the CITROËN network periodically
for further information and to obtain any possible updates».
CAR 050007

Advertisement

loading
Need help?

Need help?

Do you have a question about the C5 2000 and is the answer not in the manual?

Questions and answers

Related Manuals for CITROEN C5 2000

Summary of Contents for CITROEN C5 2000

  • Page 1 2000 «The technical information contained in this document is intended for the exclusive use of the trained personnel of the motor vehicle repair trade. In some instances, this information could concern the security and safety of the vehicle. The information is to be used by the professional vehicle repairers for whom it is intended and they alone would assume full responsibility to the exclusion of that of the manufacturer».

  • Page 2: This Handbook

    PRESENTATION THIS HANDBOOK CITROEN C5.
  • Page 3 INDEX GENERAL INJECTION BRAKES HYDRAULICS ENGINES ELECTRICAL IGNITION CLUTCH-GEARBOX AIR CONDITIONING AXLES-SUSPENSION...
  • Page 4 (label on front pillar close to driver’s door). (label on front pillar close to driver’s door)
  • Page 13 (Impossible with an automatic gearbox).
  • Page 18 (in the high position, if hydropneumatic suspension). (oil temperature 80°C). (time for draining to last drops = 15 minutes). (to allow the cartridge to fill). (to allow oil to stabilise for 5 minutes).
  • Page 21 (With additional heating)
  • Page 22 (approx. 2.5%) (3-door)
  • Page 23 (complying with ACEA 98 norms).
  • Page 41 (in the order 1 to 10)
  • Page 42 (Distribution end).
  • Page 43 (Sintered washer) (Steel washer)
  • Page 49 (Equipped with a new seal).
  • Page 50 (Order from 1 to 8) (Orer from A to H) (Order from a to m) (order from 1 to 8), (Order from A to H)
  • Page 51 (Equipped with a new seal)
  • Page 52 (Advised method).
  • Page 61 (Order 10 to 1)
  • Page 82 «c» «d»...
  • Page 83 (See corresponding operation).
  • Page 89 (See operation for removing and refitting camshafts). (use a screw 7 mm in dia.).
  • Page 92 (24).
  • Page 123 (no replacement parts). (will cause a malfunction).
  • Page 124 (no replacement parts). (no replacement parts).
  • Page 126 (refer to corresponding procedures).
  • Page 127 (white mark at "a" on the fuel supply pipe). (green mark at "b" on the fuel return pipe).
  • Page 128 (locked shut) (pipe pinched or trapped...). (low pressure) (Table below (locked open) (locked shut)
  • Page 133 (Grey marking on pipe).
  • Page 134 (black connector) (tube with blue marking) (blue connector)
  • Page 136 (blue connector) (tube with blue marking). (black connector) (Metering pump cold), (tube with white marking).
  • Page 137 (white marking) (black connector).
  • Page 150 (according to equipment) (according to equipment)
  • Page 178 (Sequence and serial no.).
  • Page 185 (See corresponding operation).
  • Page 186 (engagement and selection)
  • Page 187 (Sequence and serial no.).
  • Page 194 (See corresponding operation).
  • Page 195 (engagement and selection)
  • Page 196 (riveted on the casing). (last digits taken into account)
  • Page 198 (Large head)
  • Page 199 (Automatic gearbox). (risk of deforming the tray and damaging the hydraulic valve block). (remove the converter retaining peg just before locating)
  • Page 200 (the fault values are taken in substitution). (3rd hydraulic). (if necessary). (engine and gearbox). (this is essential after an initialisation of the ECU).
  • Page 201 (relating to comfort, gear selection quality, loss of functions). only 3rd ratio and reverse are (while ECU parameters available) are adapted to the gearbox). (auto-adaptive laws).
  • Page 202 (Pedal). ( AL 4 and 4 HP 20 ) (AL 4) (AL 4) (AL4 - 4 HP 20). (AL 4 - 4 HP 20)
  • Page 203 (emission standard L4 (auto adaptive laws).
  • Page 204 (normal operation). (with a fault).
  • Page 205 (locking and immobilisation of the vehicle). (Use of the four gears in their autoadaptive automatic function).
  • Page 206 (Eco law, autoadaptative mode). (Push-button pressed in to lock the control adjustment, springs out for the adjustment to be made)
  • Page 212 (For all rim types). (unladen and laden)
  • Page 214 (COM 2000).
  • Page 216 (to the rear of the front yokes fixing the suspension arm).
  • Page 217 (Adjustable) (Non adjustable) (Adjustable) (Non adjustable)
  • Page 220 (Power steering)
  • Page 221 (Power steering)
  • Page 223 (Adjustable) ( Non adjustable) (Adjustable) ( Non adjustable)
  • Page 225 (Adjustment)
  • Page 229 (48 pairs of poles).
  • Page 230 (48 pairs of poles).
  • Page 233 (if necessary, use a clean syringe).
  • Page 235 (Should be between «DANGER» level and «MAXI» level). (Should be between «DANGER» level and «MAXI» level).
  • Page 249 (driver’s side).
  • Page 250 (Torx 20) (Rotate it round the hinge in a clockwise direction). (Rotate it round the reservoir (6) anti-clockwise)
  • Page 251 (Risk of impurities entering the base (8)). (If it is not, clean in and around the base (8) with a paper cloth.)
  • Page 252 (New, from the replacement parts kit).
  • Page 255 (Low pressure) (High pressure).

This manual is also suitable for:

2005 c5