Related Manuals for Philips CSP530
Summary of Contents for Philips CSP530
- Page 1 Always there to help you Register your product and get support at www.philips.com/welcome Question? Contact Philips CSP630 CSP530 User manual...
-
Page 3: Table Of Contents
Contents 1 Important Safety Notice 2 Your car stereo speakers Introduction What’s in the box 3 Installation Option 1: Mount on door (front or rear) Option 2: Mount on rear tray 4 Product information 5 Troubleshooting... -
Page 4: Important
WOOX Innovations may void the user’s authority to operate the equipment. 2013 © WOOX Innovations Limited. All rights reserved. Specifications are subject to change without notice. WOOX reserves the right to change products at any time without being obliged to adjust earlier supplies accordingly. Your car stereo speakers Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. -
Page 5: Introduction
Introduction With the speakers, you can enjoy high power music with vivid sound. What’s in the box Check and identify the contents of your package: Speakers (x2) Grille net + Frame (x2) Speaker wire (x2) Screw (x8) Shrapnel (x8) Installation A depth of at least 46mm is required to mount the speaker. Measure the depth of the area where you are to mount the speaker, and ensure that the speaker does not obstruct any other components of the car. -
Page 6: Option 1: Mount On Door (Front Or Rear)
Option 1: Mount on door (front or rear) You can mount the speakers on the front/rear door of your car. Note • Make sure that nothing obstructs around the mounting location of the door. • A hole for mounting may already be cut out of the inner panel of the door (front or rear). In this case, you need to modify the board only. - Page 7 Cut out the marked area and drill the bolt holes. Remove the grille net. Strip the speaker wires and connect them to the amplifier. Black wire: connect to “-“ (negative) terminal • Black (white lined): connect to “+“ (positive) terminal • Right White lined White lined Right П а С...
- Page 8 Note • Match the “left”, “right”, “+” and “-” terminals correctly. Revised polarity may degrade sound quality. • Two 4-ohm speakers, wired in stereo, present a 8 ohm load to each channel of the amplifier. Most two channel amplifiers work well in this configuration. However, if two 4-ohm speakers, wired in parallel to a bridged two -channel amplifier, present a 2-ohm mono load to the amplifier.
-
Page 9: Option 2: Mount On Rear Tray
Follow the steps in section “Option 1: Mount in door” to mount the speakers into the rear tray: Product information Note • Product information is subject to change without prior notice. Model CSP530 CSP630 Speaker type 13 cm, 3-way coaxial 16.5 cm, 3-way speaker coaxial speaker RMS power (Watts) -
Page 10: Troubleshooting
To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, go to the web site (www.philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. - Page 12 WOOX Innovations, and is the manufacturer of the product. WOOX Innovations is the warrantor in relation to the product with which this booklet was packaged. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V.
Need help?
Do you have a question about the CSP530 and is the answer not in the manual?
Questions and answers