Charging The Battery - Disney Princess Scooter KT1003TG Owner's Manual

Charging the Battery

red battery
connector
Important! Before using the Princess Scooter for the first time the
battery needs to be charged for a full twelve hours. Only an adult who
has read and understands the following safety warnings should handle,
charge or recharge of the battery.
1. Remove the seat, as described on page 10.
2. Disconnect the red connectors.
3. Plug the charger connector into the red connector from the battery.
Only use the Kid Trax Toys charger included with the Scooter (Input:
AC 118V–, 0.5A, 60Hz Output: DC 6V, 0.6A).
4. Plug the charger into a standard 118V wall outlet.
Note: The charger may feel warm during charging. This is normal and
not a cause for concern.
5. After charging is complete (at least 12 hours, but no more than 18)
unplug the charger from the wall outlet.
6. Unplug the charger from the charging connector and connect the
battery connectors.
7. Place the seat back on the vehicle, and lock into place.
3
battery
charger
12