Advertisement
ROUGH-IN
DIMENSIONS
11-7/16"
DRAIN
(29,05 cm)
OUTLET
_
J
27"_
_
27"_
(68.58cm)
(68,58cm)
FRONT VIEW
SIDE VIEW
MECHANISM
SHIPPING
BOLT
PLASTIC
SPACER
BLOCK
SHIPPING BLOCKS
FOAM /
\
SHIPPING
POWER
PAD
CORD
SHIPPING CARTON
CORNER POSTS
DRAIN HOSE
LOCATION
OF YOUR WASHER
DO NOT INSTALL YOUR WASHER:
1.
In an area exposed to dripping water or outside
weather
conditions.
The ambient
temperature
should never be below 60 degrees F (15.6 degrees
C) for proper washer operation.
2.
In an area where it wilt come in contact with curtains
or drapes.
3.
In an area (garage or garage-type building) where
gasoline of other flammables
are kept or stored
(including automobiles).
4.
On carpet. Floor MUST BE SOLID with a maximum
slope of 1 in. (2.54 cm). To ensure vibration
or
movement does not occur, REINFORCEMENT
of
the floor may be necessary.
IMPORTANT
MINIMUM INSTALLATION CLEARANCES
When installed in alcove: Sides = 0" (0 cm),
Rear = 0" (0 cm), Top = 20" (50.8 cm).
When installed in closet: Sides = 0" (0 cm),
Rear = 0" (0 cm), Top = 20" (50.8 cm), Front = 1"
(2.54 cm).
Closet door ventilation openings required:
2 louvers
each 60 square inches (387 cm2) -- 3 inches (7.6 cm)
from bottom and top of door.
1.
2.
UNPACKING
Using the four shipping carton comer posts (two on
each side), carefully lay the washer on its left side
and remove foam shipping base.
Using a ratchet
with 3/8" socket,
remove
the
mechanism shipping bolt and plastic spacer block
from the center of the base.
NOTE: If the washer is to be transported at a later
date, the tub blocking pad, shipping bolt,
and plastic spacer block should be retained.
3.
Return the washer to an upright position.
4.
Remove the tape holding the lid shut and open the
lid.
.
6.
7.
.
Remove the foam tub blocking pad.
Remove the inlet hoses (some models have inlet
hoses already attached
to the water valve) and
enclosure package from the tub.
From the back of the washer,
remove the wire
shipping clips securing the drain hose and power
cord. On some models, PLASTIC CLAMPS secure
the drain hose to the right side of the washer
backsheet.
These clamps
form a standpipe
to
prevent water siphoning. DO NOT REMOVE THESE
CLAMPS.
Carefully move the washer to within 4 feet of the
final location for the start of the installation.
1.
2.
.
INSTALLATION
Run some water from the hot and cold faucets to
flush the water lines and remove particles that might
clog up the water valve screens.
Check inlet hoses to ensure that the rubber washers
are installed in each end (If your washer has inlet
hoses already attached to the water valve, proceed
to step 4).
Carefully connect the inlet
hoses to the water valve
(on the left side
of the
washer cabinet), tighten by
hand, then tighten another
2/3 turn with pliers.
_
DO
NOT
CROSS
THREAD
OR
OVERTIGHTEN
THESE
CONNECTIONS.
3
Advertisement
