GE JGP633 Installation Instructions Manual page 15

Installation Instructions
CHANGE COOKTOP BURNER
ORIFICES (CONT.)
Locate the LP/Propane orifices shipped
inside the literature package. They
will have a digit number and the letter "L" on
the side. (Important: Save the orifices
removed from the appliance
for future use.)
Each orifice will show a series of engraved
marks, (I, II, III, X or none),
located on the top.
These marks denote the precise location of each
orifice to the cooktop burner.
(DO00
15,OOOBTU/HR Burner (on some models)
O he 15,000 BTU/HR burner has two orifices with
markings located in the sides only. (See rating
plate on bottom of appliance).
NOTE: The main orifice is located low in the center
of the burner while the simmer orifice is located
higher behind the center of the burner.
Simmer
orifice __I
Main orifice
Model Front Left Front Right
Burner Burner
JGP633 II III
JGP970
III X
ZGU36K
Replace: With:
PGP966 III Main 175HXN -> 99HXL
Simmer 57N -> 34L
r_ Install the LP/Propane orifices in their precise
locations as noted in the illustrations above.
F1
[]
Return the natural gas orifices to the bracket
and reottach the bracket and
the instruction sheet to the pressure regulator
using the screw removed previously.
Replace the burner bases, heads, caps and
top grates. (NOTE: When re-attachinq the
burner bases to lass to units tiqhten screws
to a maximum of 10 in.-Ibs tar uauej)
15