Advertisement
Spin process
1
Put the laundries in properly
2
Put the gland in properly
3
Close the inner and outer cover of the spin tub
4
Do you need water-added Rinsing-spinnning
Water-added rinsing-spinning has an effect that can remove the surplus liquid dirt,
It works in a way as follows:
Spin
Spin for about
1~2 minutes
Remove most of
the foam extra
detergent liquid.
Note: If there needs no
spinning directly.
The effect is best when the laundries quantity is below 80% of the rated value.
5 Take the laundry out when the spinning ends.
When the spinning ends, open the top lid and the interior lid. Then take out
the depression cover and laundry after the spinning drum has stopped
rotation completely.
Note:
Refer to the Notes on Spinning carefully.
If you need
between the water hose and filling inlet.
Install the water inlet hose
The water hose should be connected
as shown in the right figure.
Notes on Spinning
Use the foam-removing spin-
ning to remove the extra deter-
gent liquid. It can both shorten
the washing time and save the
water consumption.
Fill water for
about 1 minutes
water-added rinsing-spinning , set the duration for
water-added rinsing-spinning , please check the connection
Water inlet hose
Please put in the gland properly even if the laundries
quantity is small.
. Do not leave any articles above the depression cover.
Push
Gland
Proper The laundries
are slanting
Spin for about
1~2 minutes
Remove the detergent
liquid remained
Push
Proper
Foam-removing
spinning
Water inlet entrance
No gland
Advertisement
