Choke Control; Seat Adjustment Lever - Cub Cadet Z-Force S Commercial 48 Operator's Manual

Choke Control

The choke knob controls the position of the
engine choke and is located on the RH console.
Pull the knob out to choke the engine; push the
knob in to open the choke.
Parking Brake Engagement Lever
The parking brake engagement lever is located on the left of the
seat box frame, and is used to engage the parking brake.
Pull the lever reward to stop the tractor or slow it down.
Pull the lever fully rearward and to the right; then into the short
"J" slot to engage the brake.
Pull the lever up out of the "J" slot and to the left; then
completely forward to disengage the parking brake.
Drive Pedal
The drive pedal is located on the right side
of the tractor, along the running board. Press
the drive pedal forward to cause the tractor to
travel forward. Ground speed is also controlled
with the drive pedal. The further forward the
pedal is pivoted, the faster the tractor will travel. The pedal will
return to its original position when it's not pressed.
Reverse Pedal
The reverse pedal is located on the right
side of the tractor along the running board.
Ground speed is also controlled with the
reverse pedal. The further downward the
pedal is pivoted, the faster the tractor will
travel. The pedal will return to its original
position when it's not pressed.
Cup Holders
The cup holders are located on the LH console to the left of the
operator's seat and on the LH utility bin.
Storage Tray
The storage tray is located at the rear of the LH console.

Seat Adjustment Lever

The seat adjustment lever is located below the front/left of the
seat. The lever allows for adjustment of the fore to aft position of
the operator's seat. Refer to the Assembly & Set-Up section for
instructions on adjusting the seat position.
Steering Column Adjustment (Not Visible)
The angle of the steering column can be adjusted up or down. To
adjust the steering wheel column press the pedal at the base of
the column down and move the column into the desired position
and release the pedal to lock into place.
14 S 4— c
ection ontrolS
CHOKE
& F
eatureS
Transmission Oil Expansion Reservoir (Not Shown)
The transmission oil expansion reservoir is connected by hoses
to the RH and LH transmission assemblies, and is located behind
the seat box. The function of the reservoir is to hold the natural
expansion of transmission oil that occurs as the transmission
warms up during operation. DO NOT FILL THE RESERVOIR.
Under normal operating conditions, no oil should be added
to the reservoir. The COLD oil level should be no higher than
approximately 1⁄4" (the "Full Cold" mark) above the bottom of the
reservoir. See Figure 4-1.
Full Cold Line
Figure 4-1
NOTE: Prior to the initial operation of the tractor, the oil level in
the reservoir may be slightly higher than the maximum due to air
in the oil lines. Operation of the tractor will eventually purge the
air from the lines and the oil level will settle to the maximum.