4. Supplementary information
Operating modes and LED status
Startup mode
Notes:
alert
The
LED also
flashes during internal
flash memory updates.
Do not power off while
alert
the
LED is
flashing.
mode
Don't press the
button during startup
unless you have read
and understood
Special modes on
page 30.
Normal mode
Supplementary information
Startup mode occurs from the time power is
applied until the unit is operating normally.
During the startup mode the
on or flashing. The info LEDs reflect the three
phases of startup mode:
•
Self test phase– The
and then go off.
•
Initialization phase – The
and off in sequence.
•
Diagnostics phase – The Access Point runs
diagnostics during initialization. If an error
is found during this phase the initialization
stops and an error code is displayed on the
LEDs (see Initialization error codes on
info
page 34). If no errors are found, the unit
will enter Normal mode.
During normal operation, the
the percentage utilization of the wireless LAN
connection. In this mode the upper row of
symbols (
) applies.
busy
LED will be
alert
LEDs all come on
info
LEDs go on
info
LEDs show
info
29