Miele K 12010 S-2 Operating And Installation Manual page 37

. . . the interior lighting in the
refrigerator is not working.
^ First check whether the light contact
switch is sticking or the On/Off and
temperature selector is at "0".
If this is not the case, then the lamp is
defective.
Replace the lamp as quickly as
possible.
Otherwise the winter setting cannot
function if activated.
^ Disconnect the appliance from the
mains.
^ Reach under the back of the light
cover, and pull the cover off.
^ Remove the lamp and replace with a
new one.
Lamp specification:
220 - 240 V, E 14 cap
See the old lamp for the Wattage
required.
^ Fit the new lamp and replace the
cover.
Problem solving guide
. . . the floor of the refrigerator
section is wet.
The condensate drain hole is blocked.
^ Clean the condensate channel and
drain hole.
If you still cannot remedy the fault
having followed these suggestions,
please contact the Miele Service
Department.
To prevent unnecessary loss of
temperature, it is advisable not to
open the door while waiting for the
appliance to be serviced.
37