Sharp MD-MS200W Service Manual page 14

MD-MS200W/MD-MS200/MD-MS200H
7. NORMAL Mode
Step No. Setting Method
Step 1 Test mode STOP state
Step 2 BASS button
Step 3 AUTO menu
Step 4 SKIP UP button x 6times
(Or SKIP DOWN button x 4 times)
• When the STOP button is pressed while the NORMAl menu appears, the mode changes to the TEST mode stop state.
• Indication during operation
Indication of memory capacity on main unit LCD [
: TNO
: Internal mode
: Servo state (#3: Slide, #2: Tracking, #1: Spin, #0: Focus)
: Address
LCD remote control [
: Internal mode
: Servo state (#3: Slide, #2: Tracking, #1: Spin, #0: Focus)
: Address
: Memory capacity (graphic indication)
• Selection of sound volume, BASS, etc. is possible (without indication)
• Recording is also possible.
8. Digital input display mode
Step No. Setting Method
Step 1 Test mode STOP state
Step 2 BASS button
Step 3 AUTO menu
Step 4 SKIP UP button x 7times
(Or SKIP DOWN button x 3 times)
Step 5 Digital input indication menu
Step 6 PLAY button
• When the STOP button is pressed while the digital input indication menu appears or during digital input information indication, the mode
changes to the TEST mode stop state.
• In case of analog input or digital input unlocking the indication data is _.
ƒ ƒ : Control Code
•
ƒƒƒƒ :
• Category code
• : TNO
:
• INDEX
† † :
• TIME(min.)
‡ ‡ :
• TIME(Sec.)
Display
[ T E S T ]
[ A U T O ]
] + TNO indication
Display
[ T E S T ]
[ A U T O ]
[ D I N M O N ]
Step No.
Setting Method
Step 5 NORMAL menu
Step 6 PLAY button
Step 7 TOC read
Step 8 Hereafter operation in normal mode
] + Level meter
Step No.
Setting Method
Step 7 FS code, channel status indication
Step 8 SKIP UP button
Step 9 U bit indication 1
Step 10 SKIP UP button
Step 11 U bit indication 2
Step 12 STOP button
Step 13 Test mode STOP state
– 14 –
Display
[ N O R M A L ]
[Refer to the
following description.]
Display
[ C ƒ ƒ ƒƒ ƒƒ ]
[ U 1 ]
[ U 2 † † ‡ ‡ ]
[ T E S T ]