Infinity PHI 51 Owner's Manual
  1. Manuals
  2. Brands
  3. Infinity Manuals
  4. Speakers
  5. PHI 21
  6. Owner's manual

Infinity PHI 51 Owner's Manual

Phi series
Hide thumbs

Advertisement

Table of Contents

P
51 - P
21
HI
HI
Owner's Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PHI 51 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Infinity PHI 51

Summary of Contents for Infinity PHI 51

  • Page 1 51 - P Owner’s Guide...
  • Page 2 ’ WNER UIDE Table of Contents Important safety precautions Introduction Unpacking the System Planning Your System Placement Wall-Mounting the Satellites Assembling the Floorstands Center and Satellite Speaker Connections Subwoofer Controls Subwoofer Connections Operation Maintenance and Service Specifications 51 - P...

  • Page 3: Important Safety Instruction

    CAUTION Declaration of Conformity RISK OF ELECTRIC SHOCK DO NOT OPEN We, Harman Consumer Group, Inc. CAUTION: To prevent electric shock, 2, Route de Tours do not remove the grounding plug 72500 Château-du-Loir, on the power cord, or use any plug FRANCE or extension cord that does not have a grounding plug provided.

  • Page 4: Unpacking The System

    Before deciding where to best place your speakers, survey your room an Infinity PHI Series study Figures 1 and 2. The illustrations depict how to position the PHI 51 The PHI Series of loudspeakers continues Infinity’s longstanding system. The PHI 21 system should be positioned according to the same commitment to accurate sound reproduction.

  • Page 5: Center Channel

    Should you have questions relating to installation, it is advisable to call Place bracket against wall and fasten two appropriate screws through the either your dealer or Infinity’s Customer Service Department for advice. bracket’s screw holes into the wall. The wall brackets have a hole in the The performance of the subwoofer is directly related to its placement back for cables that are installed into the wall.
  • Page 6 SSEMBLING THE LOORSTAND ENTER AND ATELLITE PEAKER ONNECTIONS Assembling the stand 1. The PHI stand is supplied with the base detached from the column. Turn Off All Power 2. Feed your speaker cable through the stand column. The cable can exit After placing the speakers, you are ready to connect your system.

  • Page 7: Rear Panel

    UBWOOFER ONTROLS Rear Panel Subwoofer-Level Control Crossover Adjustment Phase Switch Power Mode Switch Sub Trigger Input Line Level Input High Level Input Power Switch Voltage Switch A Few Suggestions Important! We recommend that you do not operate your speakers or subwoofer with Whenever changing cables, pulling plugs, etc., ALWAYS TURN OFF ALL the bass, treble and loudness controls set to full boost.

  • Page 8: Line-Level Subwoofer Connections

    UBWOOFER ONNECTIONS HOOSE THE UBWOOFER ONNECTION UITABLE FOR ECEIVER ROCESSOR EVEL UBWOOFER ONNECTIONS PEAKER EVEL UBWOOFER ONNECTIONS If your receiver/processor does not have subwoofer outputs for the left If you have a Dolby* Digital or DTS ® receiver/processor with a and right channels or an LFE output: low-frequency-effects (LFE) or subwoofer output: AMPLIFIER/PROCESSOR...

  • Page 9: Operation

    In the event that the trigger cable and set the Power Mode Switch to ON. your PHI system ever needs service, contact your local Infinity dealer or Adjust Gain distributor.

  • Page 10: Specifications

    Infinity continually strives to update and improve existing products, as well as create new ones. The specifications and construction details in this and related Infinity publications are therefore subject to change without notice. The Infinity PHI system should not be used if the ambient temperature is higher than 45˚ C.”...
  • Page 11 Notes: 51 - P...
  • Page 12 Infinity Systems, 250 Crossways Park Drive, Woodbury, NY 11797 USA 800.553.3332 (USA only) * Trademark of Dolby Laboratories. DTS is a registered trademark of Digital Theater Systems, Inc. Infinity is a registered trademark of Harman International Industries, Incorporated. Part no. YOMA00074-0001...

Table of Contents