Output Connections - Sonance crown Instruction Manual

output connections

Stereo 70 volt audio systems allow for speakers to be daisy chained
together. in a typical system with one zone of audio you simply run a
wire from the amplifier to the closest speaker then wire from there to
next speaker and so on.
Note: Sonance strongly recommends the use of 14 gauge or larger
direct burial grade wire.
Terminating The wire
attach the supplied spade connectors to the ends of your speaker
cables. once the connectors are installed then connect the spades
to the output connectors on the amplifier. once your connections
are finished place the supplied plastic cover over the connectors to
prevent a short circuit or shock hazard.
Caution: The amplifier should not be connected to AC power until all
connections are completed. High power 70 volt amplifiers present a
serious shock hazard. Do not connect speaker wires to the amplifier
until all other connections are completed.
Satellite and Subwoofer Stereo wiring examples
SLS Wiring Diagram 70V
Configuration: 4 SATs to 1 SUB or up to 8 SATs to 1 SUB
Crown CDi Series Amplifier
LS47SATs & LS10SUB or LS67SATs & LS12SUB
Left Right Left
Wiring Diagram 70V
Crown CDi Series Amplifier
LS87SATs & LS15SUB
Left
Configuration: 4 SATs to 1 SUB
Right
Left and Right
Right
Note: The subwoofer can
be connected at any point
in the daisy chain.
Left Right Left
Expandable
Note: The subwoofer can
be connected at any point
in the daisy chain.
Left Right
Expandable
Right