Table of Contents
Advertisement
Using a ChargePAK
Removing ChargePAK > Installing ChargePAK > General notes for use
ChargePAK E1 is a rechargeable battery pack provided with your EVOKE Mio. ChargePAK provides
the benefi ts of rechargeable batteries without the inconvenience of removing and recharging
separate batteries. ChargePAK is designed to be left in your unit, so if usually connected to the
mains, your product will always be charged up, ready to go.
Removing a ChargePAK
1. Switch your radio off and disconnect from the mains power supply.
2. Turn the radio over and using a coin, unlock and remove the battery compartment door. Lift the
ChargePAK out and pull gently on the connector plug to remove it. Note Damage may occur if
you attempt to remove the plug by pulling on the connecting wires or ChargePAK itself.
3. Replace the battery compartment door and re-lock.
Installing a ChargePAK
1. Switch your radio off and disconnect from the mains power supply.
2. Open the battery compartment and push the ChargePAK connector plug into the socket in the
compartment. Line up the ridges on the plug with the slots in the socket. Do not force the plug.
3. Insert ChargePAK into the battery compartment.
4. Replace the battery door and connect your product to a power supply.
5. ChargePAK will begin charging. Note When charging your ChargePAK for the fi rst time or after
an extended period of inactivity we recommend that you charge it for around 24 hours to
ensure full battery power. If ChargePAK is fl at there may be a slight delay before the battery
charging indicator is displayed.
General notes for use
It is perfectly normal for your ChargePAK to get warm to the touch in use, especially during
charging. Your ChargePAK should give years of trouble-free use under normal circumstances,
however, as for all rechargeable batteries the operating life will gradually reduce with age.
To purchase additional PURE ChargePAKs, contact your nearest PURE dealer, visit the shop on our
website at www.pure.com or call the PURE order line on 0845 045 1122.
Important: EVOKE Mio can only be powered with a ChargePAK E1 and is not compatible with any
other batteries, either disposable or rechargeable, or any other ChargePAK model.
Using a ChargePAK
10
+
+
ChargePAK
™
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the EVOKE Mio and is the answer not in the manual?
Questions and answers
We’ve lost the display - any advice?
You can adjust the brightness settings by selecting ‘Brightness’ and choosing from the following options:
- Automatic (default): The screen adjusts brightness based on ambient light.
- Manual (1–10): Turn the Tune dial to set brightness between 1 (very dim) and 10 (very bright), then push to confirm.
If the display turns off, it may be due to inactivity. The screen switches off after 7 seconds of inactivity.
If the screensaver is causing an issue, you can adjust it:
- On (default): Activates after 15 minutes of no button presses.
- Off: Disables the screensaver.
To prevent screen burn-in, it is recommended to keep the screensaver on.
If the issue persists, check the power source or ChargePAK battery.
This answer is automatically generated