Thank you for purchasing the PJB BASS CUB. A great deal of dedication and passion went into designing and building this no compromise, high performance compact-combo amplifier. It was conceived to be a dedicated amplifier for the “connoisseur” guitarist. Reading this manual will enable you to get the best performance from it so that you may enjoy many years of service.
Page 3
waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. The apparatus shall not be exposed to dripping or splashing. OVERVIEW OF THE BASS CUB Sometimes all you need is an amp that can deliver true bass tones but without the hassle of getting out a big rig amplifier.
FRONT PANEL DESCRIPTION INSTRUMENT INPUT JACK CHANNEL A This is a combo socket accepts both standard inch mono jack and XLR plug. 2. INPUT GAIN SWITCH CHANNEL A High: Higher sensitivity, high impedance input. Low: Lower sensitivity input setting for guitars with onboard electronics. MIC: Switch to this when plug in a microphone.
Page 6
13. INSTRUMENT INPUT JACK CHANNEL B This is a standard inch mono jack socket. 14. CLIP/ MUTE INDICATOR When the amplifier output is clipping, the LED will light up with red. When muted, the LED will light up with green. 15.
BACK PANEL DESCRIPTION 23. GROUND LIFT SWITCH This allows the grounding of balanced out socket to be disconnected. This is useful if you are experiencing hum caused by grounding loops/problems. 24. BALANCED LINE OUT This is an ultra-low impedance (200) balanced line out for use with recording or PA mixing consoles.
OPERATION & POSITIONING TURN THE VOLUME DOWN on the BASS CUB before plugging in your instrument. Positioning the BASS CUB for Best Sound Often, playing in different venues will cause your bass to sound different. This is partially due to the acoustics of the hall influencing the low frequency waves that are coming from your speaker.
Page 9
Unfortunately for bass players, low frequencies are always very difficult to control with room acoustics. The reproduced wavelengths of the notes you are playing often correspond to the room dimensions, in which case the reflected sound off the walls interferes with the sound from the speaker as you get further away from it.
SPECIFICATIONS Speaker Computer Optimized Vented Enclosure Speaker Frequency Response: 60Hz~15KHz Speaker Compliment: 2 x 5inch proprietary, extended-range drivers Speaker Sensitivity: 91dB/W/M Internal Speaker Impedance: 4 Ohms Dimensions: 12 W x10.8 D x 7.8 H (inch) Weight: 13.2 lbs Amplifier PJB 100watt, class A/B amplifier with digital switch mode power supply. Signal to Noise Ratio Better than 90 dB (EQ off, Volume on Full.) Impedance...
Phil Jones Bass American Acoustic Development LLC 8559 Page Avenue St. Louis, MO 63114 USA Phone: 314 814 3383 Fax: 636 536 1338 www.philjonesbass.com support@philjonesbass.com Phil Jones Bass is a division of American Acoustic Development LLC. www.philjonespuresound.com -10-...
Page 12
Phil Jones Bass Inc. 8559 Page Ave, St. Louis, MO 63114, USA Phone: 314 814 3383 Fax: 636 536 1338 www.philjonesbass.com support@philjonesbass.com...
Need help?
Do you have a question about the BG-100 and is the answer not in the manual?
Questions and answers