Table of Contents
Advertisement
Safe ARCSBIOS
8.4.1 Starting the Safe ARCSBIOS
You can start the safe ARCSBIOS in one of two ways:
•
· If the primary firmware image is unavailable when the system is powered on or
reset, the safe ARCSBIOS runs automatically. When the safe ARCSBIOS runs,
the system will emit 1 long beep and 2 short beeps. Follow the procedure in Sec-
tion 7.3 for updating the flah ROM.
•
· You can also start the safe ARCSBIOS manually as follows:
1. Power off your system.
2. Add jumper to Option 11 as described in Section 3.3
3. Power on the system
4. Proceed to section 7.3 and follow procedures.
5. Remove the jumper from Option 11 after upgrade.
Troubleshooting
8–4
Advertisement
Table of Contents
