Using Auto Lap by Position...11 Using Auto Pause ... Using Auto Scroll ... Courses ... Workouts ... Edge 500 Owner’s Manual ANT+ Sensors ... Tips for Pairing ANT+ Sensors with Your Garmin Device ... Putting on the Heart Rate Monitor ...
Page 4
Registering Your Device ... About the Edge ... Updating the Software ... Contacting Garmin Product Support ... Using the Backlight ... Buying Optional Accessories ... Specifications ... Wheel Size and Circumference ... Activity Classes ... Troubleshooting ... Index ... Edge 500 Owner’s Manual...
(page 5. Set up optional ANT+ (page 6. Go for a ride (page 7. Save your ride (page Edge 500 Owner’s Manual 8. Get Garmin Connect Training Center (page 9. Transfer history to your computer (page About the Battery This product contains a lithium-ion the first time, battery.
(shown on page 3) or the handlebars. 1. Select a suitable and secure location to mount the Edge where it does not interfere with safe operation of your bike. Edge 500 Owner’s Manual...
Bike mount disk Bands around the bike stem Edge 500 Owner’s Manual 5. Align the tabs on the back of the Edge with the bike mount notches. 6. Press down slightly and turn the Edge clockwise until it locks into place.
Icons to turn on Battery charge level GPS is on and receiving signals. GPS is turned off. Heart rate monitor is active. Speed and cadence sensor is active. Power meter is active. Edge 500 Owner’s Manual...
Press LIGHT the backlight. Press any button to extend the backlight for 15 seconds. BACK Press BACK or return to the previous menu. Edge 500 Owner’s Manual STArT/ STOP ▼▲ LAP/rESET PAGE/ MENU POwEr ENTEr to activate to cancel...
• For heart rate monitor instructions, page • For GSC 10 speed and cadence ™ sensor instructions, see • For third-party ANT+ sensors, see page 30, refer to the manufacturer’s instructions, and go to www.garmin.com/intosports. Edge 500 Owner’s Manual page...
History is only recorded while the timer is running. 3. After completing your ride, press STOP. Edge 500 Owner’s Manual Saving Your ride Data Press and hold your ride data and reset the timer. Using Free Software...
Mini-USB port under weather cap 3. Plug the small end of the USB cable into the mini-USB port. 4. Open Garmin Connect (http://connect.garmin.com), or open Garmin Training Center. 5. Follow the instructions included with the software. Edge 500 Owner’s Manual...
5. Enter a time, distance, or calorie amount. 6. Go for a ride. Each time you reach the alert amount, the Edge beeps and displays a message. Edge 500 Owner’s Manual NOTE: To turn on audible tones for messages, see page Using Advanced Alerts...
2. Select Auto 3. In the select 4. Enter a value. 5. Customize optional lap data fields (page 6. Go for a ride. ® Settings > Bike Settings Lap. Auto Lap Trigger field, Distance. 37). Edge 500 Owner’s Manual >...
Lap Press Only trigger the lap counter each time you press and each time you pass any of those locations again. Edge 500 Owner’s Manual • Select trigger the lap counter at the GPS location where you press START during the ride where you press LAP.
4. Go for a ride. The training data pages scroll to pause automatically. You can press to manually switch pages. page 37). START to RESET), select Time - Elapsed data field. Settings > Bike Settings Scroll. Edge 500 Owner’s Manual > PAGE...
You can add course points, or places on your course that you want to remember, such as water stops or distance goals. Edge 500 Owner’s Manual Creating Courses with Your Edge Before you can create a course, you must have history with GPS track data saved to the Edge.
Page 18
5. Press START. History is recorded even if you are not on the course. The “Course Complete” message appears when you finish. 6. Go for a ride. 7. Press BACK PAGE to view the data pages: Edge 500 Owner’s Manual...
Page 19
NOTE: As soon as you press START, your Virtual Partner starts the course and does not wait for you to warm up. Edge 500 Owner’s Manual START If you stray away from the course, the Edge displays an “Off Course”...
After you create a workout, you can use Garmin Connect or Garmin Training Center to schedule the workout for a particular day. You can plan workouts in advance and store them on your Edge. Edge 500 Owner’s Manual > Yes.
Page 21
If you select Open, you can press to end the step during your workout. Edge 500 Owner’s Manual 6. If necessary, enter a value in the field below Duration. 7. Select during the step.
A message appears, counting down the time or distance until a new step begins. Ending a Step field, select a Press in the Rest Training > Workouts. Workout. PAGE to view the data pages: to end a step early. Edge 500 Owner’s Manual...
To make a permanent change to a workout, edit the workout in Garmin Connect or Garmin Training Center and then transfer it to your Edge. Edge 500 Owner’s Manual Editing a workout Using the Edge 1. Press and hold MENU.
Garmin device and only takes a few seconds when the sensors are activated and functioning correctly. • When paired, your Garmin device only receives data from your sensor, and you can go near other sensors. Edge 500 Owner’s Manual...
Heart rate Monitor Strap Slot Heart rate Monitor (Front) Electrodes Heart rate Monitor (Back) Edge 500 Owner’s Manual 2. Press the tab down. 3. Wet both electrodes on the back of the heart rate monitor to create a strong connection between your chest and the transmitter.
2. Select Heart Rate NOTE: You can customize your maximum heart rate, resting heart rate, and heart rate zones using Garmin Connect or Garmin Training Center (page 37). page 31). Settings > Bike Settings Zones. > Edge 500 Owner’s Manual >...
Monitor Battery The heart rate monitor contains a user-replaceable CR2032 battery. NOTE: Contact your local waste disposal department to properly dispose of batteries. 1. Locate the circular battery cover on the back of the heart rate monitor. Edge 500 Owner’s Manual...
6. Use a coin to twist the cover clockwise so the arrow on the cover points to CLOSE. Edge 500 Owner’s Manual Installing the GSC 10 Both magnets must be aligned with their respective indication lines for the Edge to receive data.
Page 30
The spoke magnet can face away from the GSC 10 if there is not enough room between the sensor arm and the spoke. The spoke magnet must line up with the indication line on the sensor arm. Edge 500 Owner’s Manual Indication line...
Page 31
7. Move the sensor arm to within 5 mm of the spoke magnet. You can also tilt the GSC 10 closer to either magnet for improved alignment. Edge 500 Owner’s Manual 8. Press the Spoke magnet GSC 10. The LED turns red, then green.
Non-Zero Averaging for Cadence Data The non-zero data-averaging setting is available if you are training with an optional cadence sensor. The default setting is to exclude zero values that occur when you are not pedaling. Edge 500 Owner’s Manual...
1. Locate the circular battery cover on the side of the GSC 10. Battery cover CR0 battery Edge 500 Owner’s Manual 2. Use a coin to twist the cover counter-clockwise until it is loose Data Avg. > enough to remove (arrow points to unlocked).
To turn the non-zero averaging on or off, press and hold MENU, and select Settings Bike Settings > > Bike Settings Power Zones. > Data Avg. > Edge 500 Owner’s Manual >...
A smaller elastic strap is sold separately. Go to strap is too big. http://buy.garmin.com. Edge 500 Owner’s Manual Stay 10 m away from other ANT sensors while pairing. Bring the device within range (3 m) of the heart rate monitor while pairing.
Page 36
Move away from sources of strong electromagnetic fields and some 2.4 GHz wireless sensors, which can interfere with your heart rate monitor. Sources of interference may include high-voltage power lines, electric motors, microwave ovens, 2.4 GHz cordless phones, and wireless LAN access points. Edge 500 Owner’s Manual...
Edge history can also include heart rate, cadence, and power. NOTE: History is not recorded while the timer is stopped or paused. Edge 500 Owner’s Manual Viewing History 1. Press and hold MENU. 2. Select to learn how 8) to 3.
Edge, but creates a very accurate record of your ride. to delete to delete to delete to reset the NOTE: This does not delete any history. 30) is paired, the Edge records Edge 500 Owner’s Manual...
1. Connect the USB cable to a USB port on your computer. 2. Pull up the weather cap from the mini-USB port. Edge 500 Owner’s Manual 3. Plug the small end of the USB cable into the mini-USB port. Your device appears as a removable...
USB cable. 1. Complete an action: • For Windows computers, click the eject icon system tray. • For Mac computers, drag the volume icon to the Trash 2. Unplug the device from your computer. Edge 500 Owner’s Manual in your...
3. Select one of the pages. 4. Select the number of data fields you want to see on this page. Edge 500 Owner’s Manual To turn off an optional page, set the number of data fields to zero. 5. Use ▼, ▲, and change the data fields.
Heart rate in beats per minute (bpm). HR – %HRR Percentage of heart rate reserve (maximum heart rate minus resting heart rate). HR – %Max. Percentage of maximum heart rate. HR – Avg. ** Average heart rate for the ride. Edge 500 Owner’s Manual...
Page 43
HR Graph ** Line graph showing your current heart rate zone (1 to 5). Edge 500 Owner’s Manual Data Field Description HR Zone ** Current range of heart rate (1 to 5). The default...
Page 44
Time Stopwatch time. Time – Avg. Average time to complete the laps so far. Time Total time recorded - Elapsed from pressing rESET. Time – Lap Amount of time in the current lap. Edge 500 Owner’s Manual STArT...
Changing the Audible Tones 1. Press and hold MENU. Settings System 2. Select > Edge 500 Owner’s Manual 3. Turn the tones for keys and messages on or off. Changing the Backlight 1. Press and hold MENU. 2. Select Display.
Down Setting This feature automatically turns the to modify Edge off after 15 minutes of inactivity. 1. Press and hold MENU. 2. Select Power 3. Select (page Settings System Auto > > Down. or Off. Edge 500 Owner’s Manual 42).
Calorie expenditure and heart rate analysis technology is provided and supported by Firstbeat Technologies Ltd. For more information, go to www.firstbeattechnologies.com. Edge 500 Owner’s Manual Updating Your Bike Profile You can customize three bike profiles. The Edge uses the bike weight, the odometer value, and the wheel size to calculate accurate ride data.
Garmin Connect or Garmin Training Center Viewing Your Speed Zones > 1. Press and hold MENU. Settings 2. Select Speed Zones. Edge 500 Owner’s Manual field, select an option: to change the (page Bike Settings > >...
Edge (such as the GSC 10. The next time you turn on the Edge, it will search for satellite signals again. Edge 500 Owner’s Manual Satellite Page The satellite page shows your current GPS satellite information. To view the...
If you do not want to use a saved elevation point, you must delete the elevation point from your Edge. 1. Press and hold MENU. Elevation 2. Select > 3. Select the elevation point you want to delete. 4. Select Delete. Edge 500 Owner’s Manual Points. Points.
About the Edge To display important software information and your unit ID, press and hold MENU, and select About Edge. Edge 500 Owner’s Manual Updating the Software 1. Select an option: • Use WebUpdater. Go to www.garmin.com/products /webupdater.
(W × H) LED backlight Water IPX7 resistance Data storage Approximately 50 MB (at least 180 hours of ride data, typical use) Computer interface Battery type 700 mAh rechargeable, built-in, lithium-ion battery Battery life 18 hours, typical usage Edge 500 Owner’s Manual...
Page 53
GPS receiver High-sensitivity integrated GPS receiver Altimeter Internal barometric altimeter Edge 500 Owner’s Manual Bike Mount Specifications Physical size 1.5 × 1.5 × 0.36 in. (W × H × D) (37.8 × 37.8 × 9.2 mm) Weight 0.28 oz. (7.9 g)
Page 54
GSC 10 Specifications Physical size 2.0 × 1.2 × 0.9 in. (5.1 (W × H × D) × 3.0 × 2.3 cm) Weight 0.9 oz. (25 g) Water IPX7 resistance Transmission Approximately 9.8 ft. range (3 m) Edge 500 Owner’s Manual...
Size and Circumference The wheel size is marked on both sides of the tire. To modify your bike profile, page Edge 500 Owner’s Manual wheel Size L (mm) 12 × 1.75 14 × 1.5 1020 14 × 1.75 1055 16 ×...
Activity Classes How active are you? No exercise Occasional, light exercise Regular exercise and training Daily training The activity class information is provided by Firstbeat Technologies Ltd., portions of which are based on Jackson et al. “Prediction of Functional Aerobic Capacity Without Exercise Testing,”...
You should see a new removable disk drive in My Computer Edge is in USB mass on Windows computers and a mounted volume on Mac storage mode? computers. POwEr appears. to clear all user data. buildings and trees. (page rESET simultaneously rESET until the message 41). Edge 500 Owner’s Manual...
Page 59
Edge history. I need to replace the Go to http://buy.garmin.com, or contact your Garmin dealer. bands for the mount. Purchase bands made of EPDM only. Edge 500 Owner’s Manual MENU while you connect the Edge to your computer. MENU Continue pressing for 10 seconds or until the Edge goes into mass storage mode.
Need help?
Do you have a question about the EDGE 500 and is the answer not in the manual?
Questions and answers