Related Manuals for Power Craft PAC-18/5K2
Summary of Contents for Power Craft PAC-18/5K2
- Page 1 GB Subject to change USERS MANUAL Art. No. CDM6055 PAC-18/5K2 11/2006 www.servotool.com GB/IRE-0607-19...
- Page 2 Fig.A Fig.B Fig.C Powercraft Powercraft...
- Page 3 Fig.D Fig.E Powercraft Powercraft...
- Page 4 CORDLESS COMBI SET DECLARATION OF CONFORMITY (GB) The numbers in the following text correspond with the pictures at pages 2 + 3 We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents Warning! Always read the instruction for electrical products carefully before use.
- Page 5 • Push the lower half of the direction switch (3) up to loosen screws. Jig Saw No load speed 1700/min Blocking the direction switch Max. cutting depth in wood 50 mm After use block the direction switch by pressing the lock to the left into the lock position. This Max.
-
Page 6: Safety Instructions
Operation 2. SAFETY INSTRUCTIONS • Switch on and off the torch with the sliding-switch (1) • Point the swivel action head in the desired direction (2) Explanation of symbols In this manual and/or on the machine the following symbols are used: Replacing the bulb •... - Page 7 These can cause the saw to jam dangerously. Also watch out for this with waste wood. General safety instuctions This often requires less careful sawing, so there is a danger that you may not be quite so Warning! Read all instructions. Failure to follow all instructions listed below may result in careful about watching out for irregularities in the wood.
- Page 8 g. If devices are provided for the connection of dust extraction and collection facilities, • The ventilating apertures (3) on the housing must remain clear to ensure optimum cooling ensure these are connected and properly used. Use of these devices can reduce dust of the motor.
- Page 9 Service Ensure that the direction reversing switch (5) is always set to 'R' during drilling. Please use a qualified expert who uses original replacement parts to repair your power tool. This will ensure proper functioning of the power tool. b. Caution! The use of any accessories or additional tools other than those recommended in Switching the device on and off this manual may lead to an increased risk of injury.
- Page 10 attempting to operate this product and save these instructions. When the machine is not being used over a longer period of time, the battery has to be charged fully first. The battery has to be stored in charged condition. Always check that the voltage on the batterypack corresponds to the voltage on the rating plate.
Need help?
Do you have a question about the PAC-18/5K2 and is the answer not in the manual?
Questions and answers