Power On; How To Power On; Back-Up; Reset To The Initial Status - Hammond XK-3C Owner's Manual

20

HOW TO POWER ON

After connecting your XK-3C to the power outlet, please perform the following steps before switch-
ing on the power. To avoid possible damages to speakers, please do not change the order of the steps.

BACK-UP

RESET TO THE INITIAL STATUS

RESET FOR XK-SYSTEM

POWER ON

STEPS TO TAKE
1. Set the MASTER VOLUME Knob at 0 (minimum), before switching the power on.
2. Switch on the POWER on the rear panel. "PLAY" Mode appears, following the TITLE, in the
Display window.
It takes a few seconds before the XK-3C gets ready, because of the circuit-protection
devices.
It requires 10 to 20 seconds to warm up the tubes to get ready, when the [TUBE AMP]
Button is ON.
3. Switch on the power of the amplifiers etc. connected to the XK-3C.
4. Holding down a key, adjust the MASTER VOLUME by turning the Knob.
The Preset Key [B] does not produce sound when initially first turned on. Draw the left
Drawbar(s), or press either of the Preset keys [C < ] - [A] to start.
5. Adjust the volume of the amplifiers etc.
Reverse the above steps when you switch off the power. (Switch off the power of the
amplifiers etc. first.)
Your XK-3C memorizes the setting of the keyboard immediately before it is switched off. So, The
keyboard will start with these settings when it is switched on again. This is called "Back-up".
The XK-3C is initially shipped from the factory with the Preset Key [B] in "pressed" status.
Please perform the following steps to reset the XK-3C to the initial default setting.
STEPS TO TAKE
1. Switch off the power of the XK-3C.
2. Holding the [REC/JUMP] Button, switch on the power.
3. Hold down / Keep pressing the [REC/JUMP] Button until "Loading Default..." appears on the
Display.
4. If everything is in order, PLAY Mode appears on the Display. (Completed)
If you want the Upper and Lower manual Reverse color Presets to function just like they do on B-3/
C-3 organ when using the XK-System, follow the above procedure except in step 2 press the [BANK]
instead of [REC/JUMP].
Initial Preset Bank is [B] (refer to Factory Presets), Preset Load (P. 58) works only for Drawbar
registration, Preset - Link Lower / Pedal is "Off", and MIDI IN mode (P. 96 #2) is "Lower / Pedal".
Owner's Manual