Page 1
Stainless Steel Water Dispenser Distributeur d’eau en acier inoxydable Dosificador de agua de acero inoxidable Use & Care Guide Guide d’utilisation et d’entretien Manual d uso y cuidado VWD6956BLS CAUTION: Before using water MISE EN GARDE: Avant PRECAUCIÓN: Antes de usar el...
• Never allow children to dispense hot water without proper and direct supervision. • This water dispenser is equipped with a grounded power cord plug for your safety. It must be plugged into a grounded outlet. Do not use an extension cord with your water dispenser.
YOUR VITAPUR ® WATER DISPENSER Bottle support collar Ready-To-Dispense indicator lights: Red: “flashing” Heater is in operation "on” The hot water has reached its optimum temperature and is ready for dispensing Blue: "on" The cold water has reached its optimum...
Cleaning Kit 3. Pour the water dispenser cleaner or a mixture of 0.3 gal / 1 L of vinegar with 0.3 gal / 1 L of hot water into the reservoir and wait 20 minutes.
Turn the dial clockwise between the min (cool) and max (colder) levels until the desired temperature is reached. If the water dispenser is not dispensing water, there could be a possible ice build up due to the thermostat being set too cold. If this happens, unplug the dispenser overnight and then reset.
Dispensing Hot Water This water dispenser has a power saving Insta-HOT button which activates the water heater only when pressed, so you get hot water on demand without the cost of constantly heating water! To dispense hot water, first press the Insta-HOT activation button. The red indicator light will begin flashing to indicate that the water heater is on and active.
Page 7
Cleaning the Outside of the Water Dispenser The outside of the dispenser can be wiped clean with a water dispenser cleaning solution or a mild soap and water mixture. Never use harsh chemicals or abrasive cleaners. Rinse thoroughly with clean water and then dry the surfaces.
3. Drain the reservoirs. (See Draining the Reservoirs, pg. 6). 4. Pour the water dispenser cleaner or a mixture of 0.3 gal / 1 L of vinegar with 0.3 gal / 1 L of hot water into the reservoir and wait 20 minutes.
Unplug overnight, then reset. Set thermostat set too cold. to MIN, slowly increasing based on your use and need for cold water. Water dispenser is noisy Bottle making a gurgling noise as it This is normal. fills the tank. Water dispenser is uneven.
FREQUENTLY ASKED QUESTIONS Q: Why is my water dispenser leaking? A: If you are experiencing a leak with your water dispenser please do the following to see if the water bottle or the dispenser is leaking. 1. Unplug the unit, turn off the power switch and remove the bottle.
Need help?
Do you have a question about the Water Dispenser and is the answer not in the manual?
Questions and answers