Calibration (Tc3000 And Tc5000 Only) - Bowflex TREADCLIMBER 1000 Owner's Manual

Calibration (TC3000 and TC5000 only)

Failure to calibrate your machine prior to use could result in
machine failure and could cause injury.
During the entire calibration process, stand on the side foot
support platforms or rubber mat only. Do not stand on the
walking belts during this entire process.
Note: Re-calibration is also neccessary in the event of a
power outage or if a component like a belt or motor
has been replaced.
Plug the power cord into the the wall outlet.
1-1
1-2 Turn on the Main Power Switch.
1-3 Stand on the side foot support platforms or rubber floor
mat. Do NOT stand on the belts.
1-4 Hold down the POWER and SLOWER buttons. Insert the
Safety Key.
Note: If the Safety Key is not fully inserted into the safety
keyhole, the TreadClimber
Release the POWER and SLOWER buttons. The TIME
1-5
display will read "CAL", PrSS","Strt".
1-6 Press the START/STOP button to start calibration.
Note: The belts will start and stop and the displays will show
various numbers that relate to the calibration process.
Do NOT interrupt calibration.
1-7 When calibration has finished "CAL" "PASS" wil show in
the TIME display.
1-8 Remove and re-insert the Safety Key to clear the display.
When the Bowflex TreadClimber
®
completed calibration, you may begin your workout.
Note: During calibration the 100 ft LED on the TC5000 signifies
the belt speed sesor, 1000 ft LED is the step sensor.
Some models of the TC 3000 will show the step sensor in
the DISTANCE window as a heart and the speed sensor
in the SPEED window as a heart.
Repairs and Maintenance
will not operate.
®
exercise machine has
®
Main Power Switch "On"
TC5000 Power & Slower Buttons
TC3000 Power & Slower Buttons
29
Owner's Manual