Rear Wheel Removal - Yamaha Drag Star XVS650 Owner's Manual

4. Push down hard on the handle-
bars several times to check for
proper fork operation.
5. Tighten the wheel axle to the
specified torque.
6. Install the pinch bolt and tighten it
to the specified torque.
Tightening torque:
Wheel axle:
59 Nm (5.9 m·kg)
Pinch bolt:
20 Nm (2.0 m·kg)
7. Install the speedometer cable.
PERIODIC MAINTENANCE AND MINOR REPAIR
1. Adjusting nut
2. Brake rod
3. Brake torque rod bolt ( 2)
4. Brake torque rod

Rear wheel removal

WARNING
It is advisable to have a
Yamaha dealer service the
wheel.
Securely support the motor-
cycle so there is no danger of it
falling over.
6-32
1. Loosen the axle nut. Do not re-
move it.
2. Remove the brake torque rod bolt
on the brake shoe plate side.
3. Loosen the brake torque rod bolt
on the swingarm side.
4. Remove the brake pedal free play
adjusting nut and then the brake
rod from the brake cam lever.
5. Remove panel A. (See page 6-5
for removal procedures.)
EAU01350*
EW000122
1
2
3
4
5
6
7
8
9