Restoring Factory Defaults; Initializing From Settings; Initializing With The Function Button - Buffalo LS410D User Manual

the UPS and without the power supply restored, automatic shutdown is not performed, even after the specified
time has elapsed.
• If the power supply from the UPS to the LinkStation is stopped and restarted when UPS recovery is enabled, the
LinkStation is automatically restarted.

Restoring Factory Defaults

To initialize the LinkStation to its factory default, follow this procedure.

Initializing from Settings

1
In Advanced Settings, click Management.
2
Click the icon to the right of "Restore/Erase".
3
Click Initialize LinkStation.
4
The "Confirm Operation" screen will open. Enter the displayed number, then click OK.
5
The LinkStation will be restored to its factory default settings.

Initializing with the Function Button

You can also initialize the settings with the function button.
1
Turn off the LinkStation.
2
Turn the LinkStation on with holding down the function button. The function LED will flash white.
3
Press the function button again while the LED is flashing.
4
Initialization will take 5 to 10 minutes. Do not power down the LinkStation while it is initializing and showing an
"I23: System is being initialized... " information code in NAS Navigator2 and with the power LED. When initialization
is finished, reboot your LinkStation.
Notes:
• The following settings will be initialized: admin username, admin password, IP address, and Ethernet frame size.
• To disable initializing usrname and password, navigate to Management - Restore/Erase - Edit and change "Restore
factory default settings" to "Keep current settings". Be careful with this option! If this is selected and you lose your
admin password, you will not be able to reset it.
73