Front Wheel - Yamaha TDM900 Owner's Manual

To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
a jack either under each side of the
frame in front of the rear wheel or under
each side of the swingarm.
PERIODIC MAINTENANCE AND MINOR REPAIR
1. Wheel axle
2. Front wheel axle pinch bolt

Front wheel

To remove the front wheel
WARNING
_
G
It is advisable to have a Yamaha
dealer service the wheel.
G
Securely support the motor-
cycle so that there is no danger
of it falling over.
_
1. Loosen the front wheel axle pinch
bolt, then the brake caliper bolts.
2. Loosen the wheel axle with a 19-mm
hexagon wrench.
6-38
1. Bolt (× 2)
2. Brake caliper
3. Lift the front wheel off the ground
EAU01617
according to the procedure on
page 6-37.
4. Remove the brake hose holders
EW000122
by removing the bolts.
5. Remove the brake calipers by re-
moving the bolts.
6. Pull the wheel axle out, and then
remove the wheel.
CAUTION:
_
Do not apply the brake after the
brake calipers have been removed,
otherwise the brake pads will be
forced shut.
_
6
ECA00046