Front Wheel Installation - Yamaha SR125 Owner's Manual

1. Wheel axle
2. Pinch bolt
3. Loosen the pinch bolt.
4. Remove the wheel axle. Make
sure the motorcycle is properly
supported.
NOTE:
@
Do not depress the brake lever when
the disc and caliper are separated.
@
PERIODIC MAINTENANCE AND MINOR REPAIR

Front wheel installation

1. Install the speedometer gear unit
into the wheel hub. Make sure the
wheel hub and the speedometer
gear unit are installed with the pro-
jections meshed into the slots.
2. Lift up the wheel between the front
fork legs and guide the brake disc
between the brake pads. Make
sure the slot in the speedometer
gear unit fits over the stopper on
the front fork outer tube.
3. Install the wheel axle and let the
motorcycle down.
6-31
4. Push down hard on the handle-
EAU01394
bars several times to check for
proper fork operation.
5. Tighten the wheel axle to the
specified torque.
6. Install the pinch bolt and tighten it
to the specified torque.
Tightening torque:
Wheel axle:
59 Nm (5.9 m·kg)
Pinch bolt:
20 Nm (2.0 m·kg)
7. Install the speedometer cable.
6