Subscribe to Our Youtube Channel
Related Manuals for Caple WI6126
Summary of Contents for Caple WI6126
- Page 1 Instruction manual for Slot-in Wine cabinet Model code: WI6126 Contact Caple on 0844 800 3830 or for spare parts www.4caple.co.uk...
-
Page 2: Important Safety Instructions
The wine cellar should be installed in a suitable place in order to avoid touching the compressor with the hand. If the supply cord is damaged, it must be replaced by a Caple service agent or a similarly qualified person in order to avoid a hazard. -
Page 3: Installation Instructions
INSTALLATION INSTRUCTIONS Before using your wine cabinet Remove the exterior and interior packing. • Before connecting the Wine cabinet to the power source, let it stand upright for • approximately 12 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. - Page 4 OPERATING YOUR WINE CABINET AND SETTING THE TEMPERATURE CONTROL Please use the cabinet under a ambient temperature of 5-32 ℃ , if the ambient temperature is higher than or lower than this temperature, it will cause the temperature to fluctuate in the cabinet and may prevent it reaching 5-18 ℃...
- Page 5 button for 5 seconds, LED figure will stop flashing, then revert back to the actual temperature. Note If the unit is unplugged, power is lost, or turned off, you must wait 3 to 5 minutes before • restarting the unit. If you attempt to restart before this time delay, the Wine cabinet will not start.
- Page 6 How to change the door opening This appliance has reversible doors but is delivered with a right hinged door. The left hand hinge kit comes with the unit (in the box), should you wish to reverse the hinge on your unit. ①...
- Page 7 Fitting a kitchen plinth This model is recessed to fit a kitchen plinth. A H55mm vent slot is required in the plinth to ensure air is able to ventilate correctly. See diagram below. Failure to include this vent slot will invalidate the guarantee Installation diagram...
-
Page 8: Care And Maintenance
CARE AND MAINTENANCE Cleaning your wine cabinet Turn off the power, unplug the appliance, and remove all items including shelves and rack. • Wash the inside surfaces with a warm water and baking soda solution. The solution should • be about 2 tablespoons of baking soda to a quart of water. Wash the shelves with a mild detergent solution. -
Page 9: Troubleshooting Guide
PROBLEMS WITH YOUR WINE CABINET? You can solve many common Wine cabinet problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. TROUBLESHOOTING GUIDE PROBLEM POSSIBLE CAUSE Not plugged in. -
Page 10: Humidity Maintenance System
DEFROSTING/CONDENSATION Your wine cellar is designed with an “Auto-cycle” defrost system. When the RUN cycle is OFF, the refrigerated surface of the wine cellar (interior rear wall) defrosts automatically. The defrost water is channelled into a drain pan which is located at the back of the wine cellar next to the compressor from where it evaporates. HUMIDITY MAINTENANCE SYSTEM The wine cellar is equipped with a system for maintaining the correct level of humidity.
Need help?
Do you have a question about the WI6126 and is the answer not in the manual?
Questions and answers