Convenient Functions; Hdmi Control Function - Denon AVR-3310 Owner's Manual

Convenient Functions

HDMI Control Function

When you make an HDMI connection with a TV or player compatible
with AVR-3310 and HDMI control functions, you can perform the
following operations by setting the HDMI control function of each
device.
AVR-3310 power off can be linked to the TV power
n
off step.
When you set "Output audio from amp" in the TV audio output
setup operation, you can switch the amp power on.
n You can switch audio output devices with a TV
operation.
n You can adjust AVR-3310 volume in the TV volume
adjustment operation.
n You can switch AVR-3310 input source through
linkage to TV input switching.
n When playing the player, the AVR-3310 input function
switches to the function of that player.
• When you want to listen to TV audio by AVR-3310, connect optical
digital or analog audio (vpage 15 "Connecting the Monitor (TV)").
• When using these functions set as follows: "HDMI Control"
(vpage 35) set to "ON".
NOTE
• When "HDMI Control" is set to "ON", it consumes more standby
power.
• The HDMI control function controls operations of a TV that is
compatible with the HDMI control function. Make sure that the TV
and HDMI are connected when you perform HDMI control.
• When you power off AVR-3310, the HDMI control function does not
operate. Either power on or set to standby.
• Some functions may not operate depending on the connected TV
or player. Check the owner's manual of each device for details
beforehand.
• When "HDMI Control" is set to "ON", it is not possible to assign an
HDMI terminal to "TV" at "Input Assign" (vpage 45).
1
Turn the power on for all the equipment connected
by HDMI cable.
2
Set the HDMI control function for all equipment
connected by HDMI cable.
Set "HDMI Control" (vpage 35) to "ON".
Please consult the operating instructions for the connected
b
equipment to check the settings.
b Carryout steps 1 and 2 should any of the equipment be plugged
out.
3
Switch the television input to the HDMI connected to
the AVR-3310.
4
Switch the AVR-3310 input to the HDMI input source
and check if the picture from the player is ok.
5
When you turn the TV's power to standby, check
that the power of the AVR-3310 and player also goes
on standby.
If the HDMI control function does not operate properly, check the
following points.
• Is the TV or player compatible with the HDMI control function?
• Is the AVR-3310 properly set?
• Is the "HDMI Control" (vpage 35) set to "ON"?
• Is the "Power Off Control" (vpage 36) set to "ON"?
• Are the HDMI control function settings of all equipment correct?
NOTE
Should any of the operations below be performed, the interlocking
function may be reset, in which case, repeat step's 1 and 2.
• "Input Assign" – "HDMI" (vpage 45) setting has changed.
• There is a change to the connection between the equipment and the
HDMI, or an increase in equipment.
ENGLISH