Honeywell Mercury User Manual page 30

Modem Configuration Program V1.10
Dialing Setup
Modem Timing
Alarms Setup
<F1-Load Setup>
<F2-Save Setup>
Page 30
www.honeywell.com
30
Modem Firmware......: V2.10
Modem ID............: 00000000
Call-In Phone Number: 0-000-000-0000
Type (Pulse or Tone): Tone
Dialing Speed.......: 95
Auto Answer After...: 1
Number of Retries...: 0
Wait for Dial Tone..: 2
Wait for Carrier....: 30
Comma Delay.........: 2
No Activity Time-out.: 10
Battery Low Enable..: Y
Alarm Call-In Enable: Y
<F3-Read Modem>
<F4-Setup Modem> <F6-Factory Defaults> <F10-EXIT>
Main Screen after Pressing the F3 Key
Figure 13
Modem Configuration Program (DOS)
At this point you can accept the factory defaults or change the
parameters.
Modem ID: A Modem ID number must be entered or the software
will display a message "Not All Required Fields are Filled". The
number entered must contain 8 digits. For example: if the modem ID
number is to be "1", place 7 zero's in the field prior to entering the "1",
as shown, 00000001. Each Modem ID must be unique and cannot
contain alpha characters.
Call-In Phone Number: The call in phone number is the number the
modem is to dial in the event of an alarm condition. Up to 37 characters
may be entered into this field to accommodate long distance or pager
dialing.
Tue Sep 24 07:55:50
(P,T)
milliseconds (50 - 255)
Rings (1 - 255 or 0=NO ANSWER)
(0 - 254)
seconds (2 - 255)
seconds (1 - 255)
seconds (1 - 255)
minutes (1 - 30 or 0=DISABLE)
(Y, N)
(Y, N)
<F5-Print Setup>
1996