Power Up; Login/Logout - Honeywell HEGS5BLX User Manual

3.2

POWER UP

When power is applied to the HEGS5BLX, the LCD displays the following messages:
After 5 seconds, the application starts
HEGS5BLX
Then the address of the controller is displayed.
Address = n
The controller defaults to Login mode. If the controller is communicating with the
VideoBloX control system, the following message is displayed.
HEGS is On-line
Login
If the controller is not communicating with the VideoBloX control system, the
following is displayed on the LCD.
HEGS is Off-line
Login
3.3

LOGIN/LOGOUT

Login
1. Press the soft key that corresponds to Login on the LCD display.
2. Key in your password using the numeric keyboard and press Enter. The controller is
placed in camera mode of operation. Note: Passwords are defined in the
VideoBloX Configurator.
3. To prevent unauthorized control of the system, the operator must press the Login
key again, re-enter his/her password and press Enter before any system control
operation may be carried out.
Rev. 1.01
Boot Mngr MMDDYY
519685-1980 A
Booting in 5s
030106
922.0255 Rev.A
⏐
F1
⏐
F1
(counts down to 0)
9 900.0799
20-Jun-06