Cub Cadet GT 3100 Operator's Manual page 14

D. Parking Brake Lever
Figure 6
The parking brake lever is located to
the right of the steering wheel in the
dash panel. With the brake pedal
depressed fully, push the parking
brake lever downward and release the
brake pedal to lock the parking brake.
E. PTO Switch
The PTO switch is located on the
lower/right side the dash panel. Pull
the knob outward to engage the PTO
clutch. Push the
disengage the PTO clutch.
F. Brake Pedal
Figure 7
The brake pedal is located at the front
of the right running board above the
forward and reverse pedals. Depress
to stop the tractor and disengage the
cruise control. Fully depress the brake
pedal to activate the safety interlock
switch when starting the tractor.
G. Reverse Pedal
Figure 8
WARNING:
down and behind before and
while backing. Do not oper-
ate the tractor when children
or others are around. Stop
the tractor immediately if
someone enters the area.
knob inward to
Always look
The reverse control pedal is located
on the right running board below the
brake pedal. Press the pedal down to
move in reverse.
H. Forward Pedal
The forward control pedal is located
on the right running board below the
brake pedal. Slowly press down on the
pedal to start moving forward. The
forward ground speed of the tractor is
directly affected by the distance the
pedal is depressed.
I. 12V Power Outlet
The 12V power outlet is located on the
front/right surface of the fender, below
the seat. It is used for the convenience
of plugging in accessories that require
a power source with a maximum load
of 5 amps at 12 volts.
J. Seat Adjustment Lever
The seat adjustment lever is located
below the seat. This lever is used to
adjust the seat forward or backward.
K. Transmission Release Rod
The transmission
located at the back of the tractor in the
draw bar. This rod, when engaged,
allows the tractor to be pushed short
distances by hand.
To disengage the transmission, pull
back on the rod until its locking flange
is visible outside the drawbar, then
lower the rod into the slot and release.
To reengage the transmission, pull
back on the rod, lift out of the slot and
release.
14
Figure 9
release rod is