Warning - Cub Cadet GT 2550 Operator's Manual

WARNING

The deck idler arm lever is spring loaded.
Release it slowly.
10. Disengage the deck idler arm lever from its stop
bracket and release the spring tension by rotating
the lever out and rearward (See Figure 34).
Figure 34
WARNING
If the engine has been recently operated, the
exhaust system, engine, and surrounding areas
will be hot. To avoid personal injury, allow these
areas to cool before proceeding with the
following PTO belt installation instructions.
11. Pass the PTO belt upward inside the front of the
tractor frame and install the forward end of the belt
onto the PTO clutch pulley on the front of the
engine. Ensure that the narrow side of the PTO
belt engages the groove of the clutch pulley (See
Figure 35).
Figure 35
STOP
BRACKET
IDLER ARM
LEVER
PTO
CLUTCH
PULLEY
PTO
BELT
12. Twist the two sides of the PTO belt 1/4 turn inward
to engage the narrow sides of the belt into the
grooves of the two tractor front-lower pulleys (See
Figure 36).
TRACTOR FRONT
LOWER PULLEYS
13. From the front of the tractor, push the PTO belt
through the front lift rod, then to the center of the
deck. Ensure that the forward end of the belt
remains positioned inside the front lower pulleys.
14. Install the rearward end of the PTO belt on the
upper pulley of the deck center double-pulley
(Refer to Figure 37). Ensure that the narrow side
of the belt engages the groove of the upper pulley,
and that there is no more than a 1/4 twist in the belt
between the front pulleys and the double pulley.
PTO BELT
MOWER DECK
CENTER DOUBLE
PULLEY
35
PTO BELT
FRONT LIFT
ROD/BRACKET
ASSEMBLY
Figure 36
FRONT OF DECK
Figure 37