Toshiba E-studio2555c Troubleshooting Manual page 35

1.TROUBLESHOOTING FOR THE HARDWARE
Raise the lever and open the upper receiving tray of
4
the finisher.
Open the cover of the Hole Punch Unit when it is
5
installed.
Turn the knob shown in the following figures to send the paper, and then remove the
6
misfed paper.
When the Hole Punch Unit is installed, open the front cover of the finisher and turn the 2 knobs at the same
time.
When the Hole Punch Unit is not installed
Some misfed paper may get inside of the Saddle Stitch unit depending on the location where the misfeeding
occurs. In this case, follow step 7.
Close the upper receiving tray of the finisher.
7
Place your hands on the near and far side of the lever and push to
close the tray until it clicks.
Be careful not to let your fingers be caught between the
finisher body and the upper tray of the finisher.
This could injure you.
1 TROUBLESHOOTING FOR THE HARDWARE
2
When the Hole Punch Unit is installed
Clearing a Paper Misfeed
1
33