Weber Spirit 700 LP Owner's Manual
  1. Manuals
  2. Brands
  3. Weber Manuals
  4. Grill
  5. Spirit 700 LP
  6. Owner's manual
Weber Spirit 700 LP Owner's Manual

Weber Spirit 700 LP Owner's Manual

Owner manual
Hide thumbs
Table of Contents

Advertisement

Quick Links

SPIRIT
LP Gas Barbecue
Owner's Manual
®
National
PROPANEGAS
Association
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open lid.
4. If odor continues, Keep away from the
appliance and immediately call your
gas supplier or your fire department.
Leaking gas may cause a fire or explosion
which can cause serious bodily injury or
death or damage to property.
1. Do not store spare LP Cylinder within
10 feet (3m) of this appliance.
2. Do not store or use gasoline or other
flammable liquids or vapors within 25
feet (8m) of this appliance.
700 Series
™
DANGER
WARNING
Serial Number
Please use this number in registering your warranty and
any correspondence with the factory.
WARNING: Follow all leak check procedures
carefully in this manual prior to barbecue
operation. Do this even if barbecue was
dealer assembled.
NOTICE TO INSTALLER: These instructions
must be left with the owner and the owner
should keep them for future use.
THIS GAS APPLIANCE IS DESIGNED FOR
OUTDOOR USE ONLY.
WARNING: Do not try to light this appliance
without reading "Lighting" instructions
section of this manual.
98583
3/99

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Spirit 700 LP and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Weber Spirit 700 LP

Summary of Contents for Weber Spirit 700 LP

  • Page 1 Serial Number Please use this number in registering your warranty and any correspondence with the factory. SPIRIT 700 Series ™ LP Gas Barbecue Owner’s Manual ® National PROPANEGAS Association WARNING: Follow all leak check procedures DANGER carefully in this manual prior to barbecue If you smell gas: 1.

  • Page 2: Warnings

    Improper assembly may be dangerous. Please carefully follow the assembly instructions in this manual. After a period of storage, and/or nonuse, the Weber Gas Barbecue should be checked for gas leaks and burner obstructions before using. See instructions in this manual for correct procedures.

  • Page 3: Warranty & Patents

    There are no other express warrants except as warrants to the ORIGINAL PURCHASER of this set forth herein and any applicable implied Weber Gas Barbecue that it will be free of warranties of merchantability and fitness are defects in material and workmanship from the...

  • Page 4: Patents And Trademarks

    , Flavorizer and Crossover are registered U.S. trademarks; Spirit, Gas Catcher, FlameCheck, and Spider Stopper are U.S. trademarks of Weber-Stephen Products Co., 200 East Daniels Road, Palatine, IL 60067-6266. U.S.A. Spirit is covered under the following patent nos.: U.S.A. #4,677,964;...

  • Page 5: Table Of Contents

    LP Tank Information ........25-27 FEATURES: IMPORTANT NEW FEATURES: a) Convenient tables and racks. Your Weber Gas Barbecue is equipped with a new and improved LP tank connection, that has additional b) Heavy gauge porcelain-on-steel lid seals in heat. safety features. They are: c) Rapid read thermometer for precision cooking 1.

  • Page 6: General Instructions

    The Weber Gas Barbecue is portable so you can easily stored outdoors in a well-ventilated space. change its location in your yard or on your patio. Portability means you can take your Weber Gas Barbecue with you if LP tanks must be stored outdoors in a well-ventilated you move.

  • Page 7: Assembly

    While we give much attention to our products, unfortunately an occasional error may occur. If a part is missing, do not go back to the store. Call the Weber Customer Service Center toll free 1-800-446-1071 to receive immediate assistance. Have your owner’s...
  • Page 8 Left frame Tank panel assembly Right frame Front panel Wheel frame Catch pan holder Leg frame Catch pan Frame connector Two drip pans Molded work table Manifold bracket Thermometer Molded swing table assembly Two wheels Support rod Fuel scale assembly Accessory rack Warming rack Five Flavorizer Bars...
  • Page 9 Check contents of hardware packs Two plastic buttons (actual size) Three burner control knobs Two 1/4-20 wing nuts (actual size) Two tool holders Ten 1/4 inch nylon washers Seven tubing plugs (two are spares) Two hair pin cotters Support rod holder Two wheel hubcaps Swing table end bracket Work table spacer...
  • Page 10 Set one end of wheel frame on the block of wood (or other Note - Work on carpeted area (on grass or one of the hard, protected surface). Put one wheel on axle, WEBER boxes) to protect the finish during frame assembly.
  • Page 11 Step 4 Step 6 Continue frame assembly Add front panel You will need: leg frame, wheel frame, four 1/4-20 x 1/2 inch You will need: front panel and two plastic buttons. bolts, four nylon washers and a 7/16 inch wrench. Turn frame assembly right side up.
  • Page 12 Step 7 Your Weber Gas Barbecue burner assembly has been factory assembled, pressure and flame tested. As a safety Add cooking box precaution we recommend you check the burner alignment: You will need: frame assembly, cooking box assembly, a) Do the valves fit into the ends of the burners? work table spacer, 1/4-20 keps nut, 1/4-20 x 2 inch bolt, Figure 8 (a).
  • Page 13 Step 8 Step 9 Install manifold bracket Install tank panel assembly and frame connector You will need: manifold bracket You will need: tank panel assembly, frame connector, two 1/4-20 x 1 3/4 inch bolts, two nylon washers and a 7/16 inch Hook the bracket onto the manifold at the center burner wrench.
  • Page 14 Step 10 Step 11 Add fuel scale assembly Install igniter You will need: fuel scale assembly, two 1/4-20 wing nuts Note - The igniter wires are already attached to the Gas and two nylon washers. Catcher Ignition Chamber and the igniter. This was done to factory test the ignition system.
  • Page 15 If the tank manufacturer has not resolved the issue to your valve.) One series of tanks mounts with the valve facing satisfaction, then call Weber-Stephen Products Co., front. The other tanks mount with the valve facing away Customer Service Center.
  • Page 16 Step 14 Route the hose so it will not interfere with the scale indicator rod. Check that all burner valves are off The hose and regulator are connected in the following Valves are shipped in the OFF position, but you should manner: check to be sure.
  • Page 17 When leak checks are complete, turn gas supply OFF tested. As a safety precaution you should recheck all and rinse connections with water. fittings for leaks before using your Weber Gas Barbecue. Shipping and handling may have loosened or damaged a gas fitting.
  • Page 18 Step 17 Step 18 Install Flavorizer Bars and Cooking Grates Install the bottom tray You will need: five Flavorizer Bars and two cooking You will need: bottom tray, catch pan holder, catch pan and grates. one drip pan. Set the Flavorizer Bars side to side in the cooking box. Figure 20.
  • Page 19 Step 19 Step 20 Install Lid Add tool holders, control panel and burner control knobs You will need: lid, two hinge pins and two hair pin cotters. You will need: two tool holders, control panel, two Phillips Set the lid in place. Align the hinges at the rear of the screws/washers, a Phillips screwdriver, and three burner barbecue.
  • Page 20 Step 21 Insert one end of the hinge rod into the hole in the frame. Figure 28 (a). Install Swing Table Insert the other end into the hole in the swing table end You will need: swing table assembly, support rod, support bracket.
  • Page 21 Step 22 Complete accessory installation You will need: work table, accessory rack, warming rack, three tubing plugs and thermometer. Set the accessory rack across the bottom braces in front of the frame connector. Figure 29 (a). Open the lid and set the warming rack into the slots at the rear of the cooking box.

  • Page 22: Operating Instructions

    4) Turn the tank on by turning the tank valve found to be damaged in any way, do not use the counterclockwise. barbecue. Replace using only Weber authorized WARNING: Do not lean over open barbecue. Keep replacement manifold assembly. Order from Weber- your face and body at least one foot away from the Stephen Products Co., Customer Service Center or...
  • Page 23 Manual Lighting 4) Turn the tank on by turning the tank valve counterclockwise. DANGER 5) Strike a match and put the flame into the matchlight Failure to open lid while igniting the hole in the front of the cooking box. barbecue, or not waiting 5 minutes to WARNING: Do not lean over open barbecue.

  • Page 24: Cooking

    The control settings High (H), Medium (M), Low Check that the areas under the control panel and the (L), or Off (O) are described in your Weber cookbook. The bottom tray are free from debris that might obstruct cookbook uses these notations to describe the settings of the flow of combustion or ventilation air.

  • Page 25: Lp Tank Information

    Refilling the LP tank Connecting the filled LP tank WARNING: Make sure that the LP tank valve is We recommend that you refill before the scale indicator closed. Close by turning clockwise. reaches "E". Note - If you run out of fuel, check the indicator setting DANGER and/or adjust the fuel scale indicator setting with the scale Do not use an open flame to check for gas...
  • Page 26 Figure 5 (a). Push the male fitting of the If leak does not stop, turn off the gas and contact regulator into the quick disconnect, and maintain Weber-Stephen Customer Service. Do not use the pressure. Slide the collar closed. Figure 5 (b). If it barbecue.

  • Page 27: Safe Handling Tips For Lp Gas

    The LP tank and connections supplied with your Liquid Propane (LP) gas is a petroleum product as are Weber Gas Barbecue have been designed and tested gasoline and natural gas. LP gas is a gas at regular to meet government, American Gas Association and temperatures and pressures.

  • Page 28: Annual Maintenance

    Note - Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be Inspection and Cleaning of the Weber Spider rinsed with water after checking for leaks. Stopper Guards WARNING: Do not ignite burners while leak checking.

  • Page 29: General Maintenance

    Weber Spider Stopper Guards for the correct air and gas mixture. The correct flame pattern is shown in Figure 11. Your Weber Gas Barbecue, as well as any outdoor gas appliance, is a target for spiders and other insects. They Tips occasionally yellowish can nest in the venturi section of the burner tubes.
  • Page 30 d) Unlatch the Spider Stopper Guards and remove. g) Lift and twist the burner assembly slightly, to separate Figure 14. the crossover tube from the burners. Figure 17. Remove the burners from the cooking box. Crossover tube Figure 17 Figure 14 e) Remove the manifold bracket and unscrew the two h) To reinstall the burners, reverse steps c) through g).
  • Page 31 Figure 19 CAUTION: If the Spider Stopper Guards do not fit Figure 20 tightly, contact Weber-Stephen Customer Service. Check that the Crossover Ignition button pushes the WARNING: After reinstalling the gas lines, they igniter (button) down, and returns to the up position.

  • Page 32: Troubleshooting

    Check adjustment of fuel scale. Fuel scale must be adjusted with Fuel scale shows that there is gas in the LP an empty tank. tank, but tank is empty. If problems cannot be corrected by using these methods, please contact Weber-Stephen Customer Service.
  • Page 34 12-13 58-59...

  • Page 35: Parts Listing

    If a part is Parts can be ordered directly from Weber-Stephen missing, do not go back to the store. Call the Weber Products Company by phone or mail. Customer Service Center toll free 1-800-446-1071 to receive immediate assistance.
  • Page 36 INAL HANKS hank you for choosing a Weber Barbecue. Our family here at Weber has worked hard to produce the highest quality products for your satisfaction. While we give much attention to our products, an occasional error may occur. Our knowledgeable Customer Service staff is prepared to help you with any problems with parts or assembly.

Table of Contents