GE Autotrol Performa ProSoft 960 Series Installating And Operation Manual page 9

Parameter
Name Description
P6 Refill controller
Regenerant
P7
draw value
P8 Not used
P9 Backwash time
P10 Slow rinse time
P11 Fast rinse time
P12 Units of Measure
P13 Clock mode
Calendar
P14
override
P15 Reserve type
Fixed reserve
P16 capacity or initial
average value
P17 Operation type
Salt/capacity
P18
change lockout
P19 Factory defaults
Table 3 - Level II Programming Parameters
Minimum
Range of Values
Increments
1 to 99 1
1 to 99 1
NA NA
3 to 30 1
8 to 125 1
2 to 19 1
0 to 1 1
0 to 1 1
0 to 30 1
0 to 3 1
0 to 70 1
0 to 2 1
0 to 1 1
1
Units of
Default
Measure
33
25
NA NA
14 Minutes
40 Minutes
4 Minutes
0
0
0 Days
0
Percent of
30
capacity
2
0
99
9
Notes
Enter the value molded into the
end of the refill controller.
Select number from Table 4 and
enter that number.
NA
Skip this parameter to accept the
default or enter a value.
Skip this parameter to accept the
default or enter a value.
Skip this parameter to accept the
default or enter a value.
0 = U.S., 1 = metric. Skip this
parameter to accept U.S. or enter
1 for metric.
0 = 12-hour clock.
1 = 24-hour clock. Skip this
parameter for a 12-hour clock or
enter 1 for a 24-hour clock.
0 = no calendar override. Skip this
parameter for no calendar
override or enter a value.
0 = variable reserve, 1 = fixed
reserve, 2 = variable reserve with
immediate regen,
3 = fixed reserve with immediate
regen. Skip this parameter to
accept the default or enter a
different reserve type.
Description depends on the value
entered for P15. Skip this
parameter to accept the default or
enter a different value.
2 = 5-cycle
cocurrent conditioner.
0 = none, 1 = salt/capacity change
locked out. Skip this parameter to
accept the default or enter 1 to
lock out salt/capacity change.
Loads in a set of default values.
Refer to the Special Notes for
Level II Parameters section in this
manual. Do Not Change.