Page 2
Parts and Service For Spare Parts and Servicing, please contact your local dealer, or Clarke International on one of the following Numbers: Parts and Service Tel: 020 8988 7400 Parts and Service Fax: 020 8558 3622 or e-mail as follows: Parts: Parts@clarkeinternational.com...
Page 3
Features and Use The Jumpstart 4000 is a rechargeable 12 Volt power supply which can be used to start a car in the event of a flat battery. The unit can also be used to power such things as Mobile Phones, Radios, Electric Coolers etc., via a cigar lighter type socket.
Do not operate the Jumpstart if any of the cables are damaged. Consult your Clarke dealer for repair or replacement of the parts. • Do not operate the Jumpstart if the case is damaged. Consult your Clarke dealer or a qualified person for inspection and repair. •...
Recharge the battery after every use. Recharge the battery every 3 months NEVER leave your Jumpstart 4000 battery in a state of discharge. Follow the above rules to ensure maximum working life from your Jumpstart battery Two means of charging the battery are Fig.
Page 6
Charging using the 12 Volt Adaptor Plug the cable into the socket at the front of the unit, then into the cigarette lighter receptacle on the vehicle and start the engine. The green LED will illuminate on the adapter, and the red LED on the charger to denote charging is in progress. Continue to charge until the voltmeter registers ‘Battery Charged’...
Page 7
Using as a 12Volt Power Supply The unit has a cigarette lighter type socket located on the side of the casing (see Fig. 1, 8). that allows connection via a standard DC connector to other DC electrical equipment. WARNING: Be Aware that a fully charged 12V battery can have an output of approx.13.5V. Consult the appliance handbook to ensure it is safe to operate from a 12V battery.
Need help?
Do you have a question about the Jumpstart 4000 and is the answer not in the manual?
Questions and answers