Chapter 1 Components
1.2 Drive Enclosures
■
Dual expander type
Power Supply Unit
Figure 1.19 Rear view of drive enclosure (dual expander model)
1.2.3
Components (Front)
This section describes the operation panel and the disks in the front of the drive enclosure.
■
Operation panel
An operation panel has LEDs, an AUTO POWER switch, a MODE SELECT switch, and an IP
RESET switch.
POWER LED
READY LED
FAULT LED
IDENTIFY LED
Figure 1.20 LEDs on the front side of the drive enclosure
●
Part explanation
•
AUTO POWER switch
The AUTO POWER switch of the drive enclosure is turned to "OFF" as the factory setting,
and should not be turned to "ON".
•
MODE SELECT switch
Enables the device power to be turned on via power linkage.
The MODE SELECT switch is enabled for the factory default setting. Do not change to OFF.
•
LEDs
The states of LEDs are listed below.
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
Expander (EXP#0)
(PSU#0)
With a front cover
Copyright 2013 FUJITSU LIMITED
Expander (EXP#1)
Without a front cover
24
Power Supply Unit
(PSU#1)
AUTO POWER switch
MODE SELECT switch
This switch is not used.
P3AM-5512-05ENZ0