Table of Contents
Advertisement
Quick Reference
When servicing or loaning your vehicle to others, your system should be placed in Valet Mode. Valet Mode prevents the system from remote starting and
disables all alarm functions.
IMPORTANT: While in Valet Mode the remote will still control power lock and unlock systems. The parking lights will not flash.
The system can be put into valet one of two ways:
1. You can put the system into valet by turning the ignition key <on> and then <off> five times within 7 seconds. The parking lights will flash
once to confirm the system is in Valet Mode. Shortly after the first flash, the parking lights will flash twice.
2. (Optional Feature) If you purchased the secure valet switch option, you will not be able to put the system into valet until the proper code has been entered
with the secure valet switch. Until programmed, the default code is (3, 3).
You can exit Valet Mode through the following procedure:
On either 1 Button remote, turn the vehicle’' s ignition <on> and then tap the button 5 times, waiting a second between each tap. Your vehicle will flash the
parking lights twice and exit valet mode.
By Firstech, LLC
4
The only regular maintenance this system requires is remote control battery replacement.
battery.
One Button Remotes:
First, remove the small Phillips screw located on the back of the remote. Once the screw has been removed, gently pull the remote apart being careful to not
touch the circuit board. The 1BR-AM and 1BAMR-C and 1BAMR-900SH requires two CR2016 batteries. These specialty batteries can be purchased from your
local Firstech dealer or an electronics store.
Button
Duration
1.0 second
Twice within 1.0 second
3 second hold
5 taps
No programming is required when replacing the
Function / Description
Lock/Arm. LED will come on solid then flash.
Tap the button twice within 1 second and the system will
unlock/disarm the vehicle
When your vehicle is off, hold for 3 seconds to start.
Repeat to shut your vehicle off.
Takes system out of Valet Mode. Will not put into Valet Mode
5
By Firstech, LLC
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 1BR-AM and is the answer not in the manual?
Questions and answers
My remote start will no longer start my car. Goes through all the motions of starting but no start. Lights blink three times indicating receiving signal then pauses and gives 10 blinking lights afterwards
The CompuSTAR 1BR-AM remote start is not starting the car and is showing three blinks followed by ten blinks because there is a remote start error. The three parking light flashes indicate a remote start error occurred. The ten additional blinks likely represent a specific error code that can be diagnosed using the "remote start error diagnostic" section in the manual.
This answer is automatically generated