Cutting Height Adjuster
The desired cutting height is set with the height pin.
The cutting height pedal releases the deck lift to place
the deck at the selected height.
For transport, push the lift pedal fully forward until the
deck lift latches in the transport (highest) position.
Seat Adjustment Lever
The seat can be adjusted lengthways. The lever is
located under the right side of the seat (as seen by the
driver in the seat). When making adjustments the lever
is moved to the left.
IMPORTANT INFORMATION
Seat should not be adjusted while unit is in
motion.
Hydro Release Levers
The levers are located on each side of the rear of the
unit below the rear engine plate. The bypass linkage is
used when manual pushing or pulling the unit.
See Moving Machine By Hand in the Operation
section.
WARNING!
Bypass linkages are located close to the
muffler. To prevent burns, the engine
should be shut off and allowed to cool
before the bypass linkage levels are
handled.
CONTROLS
1. Release pedal
2. Height pin
Cut height selection pedals
Seat adjustment
Right side, ZT linkage
2
1
8058-223
8065-125
8065-097
23