Tools And Materials Required; Remove The Packaging - GE CV936 Owner's Manual & Installation Instructions

TOOLS AND MATERIALS REQUIRED

(NOT SUPPLIED)
Pencil and
tape measure Flat blade screwdrivers
Electric drill with
1/8" and 3/8" bits
Spirit level
Flashlight
Pliers
Hammer
Wire Cutter/Stripper
Ladder
Additional Materials:
• 120V 60Hz. 15 or 20 Amp, 2 wire with ground.
Properly grounded branch circuit.
• Strain relief for junction box.
• 7" round metal duct or 3¼" x 12" rectangular duct, length
to suit installation.
Installation Instructions
Duct tape
Phillips and
¼" pivoting hex socket
Safety glasses
cUL Listed Wire nuts
Metal snips
Saber saw or Key Hole Saw
Allen Wrench

REMOVE THE PACKAGING

• Remove parts package from the "V" shaped cardboard
insert. Remove insert. Remove shipping pads.
• Lift the hood out of the box.
CAUTION:
Lift hood by grasping the outside edges of the exhaust
opening on the top. Do not lift hood by the exhaust
opening divider – damage will occur.
Wood
Duct
Mounting
Transition
Support
Mounted on
• Remove transition duct piece from the inside of the
hood. Discard screws.
• The vent hood motor is shipped secured to the skid
with 4 screws. Locate and remove 2 screws on each
side of the motor. Discard the shipping skid.
• From the inside of the hood, remove shipping screws
holding the wood mounting piece to the back side of
the hood. Set aside wood mounting piece and screws
for later installation. Do not discard.
• Remove junction box cover and knockout.
• Install strain relief onto back or top of hood.
• Remove all tape and packing material from the hood,
duct transition and motor.
1 Ft = 0.3 m
1" = 2.5 cm
11
Parts
Package
Hood
Motor
Skid
Shipping Carton
Hold Down Screws
Hold Down Screws