Film (Film Speed, Mid-Roll Rewind, Film Advance Mode, Etc.) - Nikon F100 Instruction Manual

Film
• Setting and confirming film speed
Rotate the Main-Command Dial while pressing the film
speed ° button to set film speed in use.
• Film speed can be set to s and between ISO 6-6400 in 1/3 steps by rotating
the Main-Command Dial.
• When film speed is set to s and DX-coded film is installed, film speed is
automatically set between ISO 25-5000. Film speed can also be set manually
with DX-coded film to have an effect of increased or decreased film sensitivity.
• Film speed can be set between ISO 6-6400 with non-DX-coded film.
• Press the ° button to confirm the film speed set on the camera.
· 5: When film speed is set to s and non-DX-coded film is loaded, a, s
and Err blink in the LCD panel after film is advanced to the first frame. This
warning indication can be changed to appear when the power switch is turned
on (page 71).
• Mid-roll rewind
To rewind film at mid-roll, press the two film rewind
buttons „ simultaneously for approx. 1 sec.
• o–– blinks in the LCD panel during film rewind and the frame counter counts
backwards until rewind is complete.
• Film is completely rewound when the frame counter shows blinking "E". (E
appears without blinking when the exposure meter is off.) Open the camera
back and remove the film cartridge.
34