Do you have a question about the DSFN 1530 and is the answer not in the manual?
Questions and answers
anne smith
April 3, 2025
programme does not arrive at the end of its cycle
1 comments:
Mr. Anderson
April 3, 2025
The Beko DSFN 1530 dishwasher may not complete its cycle due to the following reasons:
1. The door is not fully closed, possibly due to a faulty door latch or misaligned door hinges. 2. Power issues such as an unplugged power cable or a blown fuse. 3. Water supply problems, like the water inlet tap being closed. 4. The machine was not turned on using the On/Off button.
Check each of these areas to identify and fix the issue.
Page 2
Welcome Dear customer Congratulations on your choice of a Beko quality dishwasher which has been designed to give you lasting service. Please read these instructions before installing the dishwasher and using it for the first time. The information contained herein is provided to avoid accidental risks and/or damage to your appliance Make sure you understand the controls prior to using your appliance.
TABLE OF CONTENTS 1. Know your dishwasher / 6. Operating the dishwasher specification Standards and testing information / EC 7. How to clean your machine 21 Declaration of conformity Upper spray arm Lower spray arm 2. Warning and safety information 8.
Specification Load Capacity : 12 Place settings Height : 850 mm Width : 598 mm Depth : 598 mm Depth/Height (without worktop) : 570 mm / 820 mm Net weight : 49 kg Supply voltage : 220-240 V ~ 50 Hz Fuse currrent : 13 A Total power...
Warning and safety information Electrical Safety Never allow your children to play on or sit onto the front door when the front The dishwasher should only be door is open. operated on the voltage specified. For electrical safety, only earthed plugs After unpacking your machine, keep and sockets should be used.
The door of your machine is designed human health due to the presence of to support the weight of a full basket hazardous substances. when the lower basket is pulled all the way out. Never place any other load Energy and water saving on the door, otherwise the machine Scrape excess food from the dishes may tip over.
Hot Air Drying If in doubt, contact the manufacturer of the item. Hot Air Drying ensures your dishes are dried efficiently. Do not overload your dishwasher or do not load items other than those mentioned in this manual. Before first use After unpacking your dishwasher, Installation check the machine against any possible transportation damage.
‘E’ or with the the mains lead must be replaced by symbol or coloured green a Beko Authorized Service Agent and yellow or green. personnel or a similarly qualified person. Connect the blue (neutral) wire to the terminal in the plug marked ‘N’...
Water inlet hose connection Drain Hose Connection Make sure your plumbing is suitable to Fit the drainage hose of your machine install your new dishwasher. If in doubt to the drainage pipe without bending. contact a qualified plumber. Secure your hose firmly to the waste The appliance must be connected pipe to avoid it coming off during the to the water mains using the new...
Installation of dishwasher will not fit under the worktop a special part replacing the top trim must be Remove all packaging before provided and installed by an Authorized positioning the machine. Service Agent. It should never be operated without a top cover. See the following diagram.
Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Good levelling is essential for correct closure and sealing of the door. Make sure your � � dishwasher is perfectly � � level using the adjustable feet.
! If you move your house, it is very Using the funnel provided will make important to make the water filling easier. hardness level adjustment of your machine according to the new After you fill the container, screw cap location you move in order to tightly back into place turning clockwise preserve the washing efficiency.
Detergent use Warning! Two-in-one and three-in-one Any brand of powder, gel and tablet detergents detergents that have been designed for You will obtain the best results from household dishwasher, may be used. your dishwasher if you use separate detergent, rinse aid and water- Keep detergents in a cool and dry softening salt.
Page 16
Using two-in-one detergent and dishwasher. Always place the tablets in the detergent dispenser rinse aid of the detergent holder. • These detergents will not give you the same drying performance that Using three-in-one detergent, you can obtain by using separate softening salt and rinse aid.
Rinse aid hardness shown in the manual. • Put the rinse aid setting at the Use only rinse aid intended for correct level. household dishwashers. Filling The rinse aid is specially formulated to be used in the dishwashers for the detergent prevention of watermarks and scale on dispenser...
Filling the rinse aid dispenser Long-stemmed glasses should lean Open the rinse aid dispenser lid by against the basket, the racks, or the pressing the button as shown in the supports not against the dishes. diagram. Fill up with rinse aid until the container The shelves on the rack are made is full to level of ’max’...
Folding plate support rods Warning ! Long cutlery, such as ladles and There are four separate “folding plate long knives, etc must be placed support rods” in the lower basket of horizontally on top of the full cutlery your dishwasher designed to allow basket or on the racks to prevent you more space to accommodate accidental injury.
Page 20
Standard loading and testing institute information � � � � � � � � � � � � � � � � � � Loading capacity: � � � � � � � Lower and upper baskets: Standard � � �...
Operating the dishwasher • be washed, open the door carefully. Turn the water tap on. Open the Care must be taken if opening the door of the machine. • door, as steam and water will escape. Check that the upper and lower Then after putting in the item, close arms can rotate freely.
How to clean your machine Cleaning your machine at regular intervals ensures longer product life and reduces the risk of recurring problems. Clean spray arms and in particular filters at least once a week ! Always unplug the appliance and turn �����������...
Clean all three filters under running tap water with a brush. Reinsert the main filter in its place. Place the coarse filter into the micro filter. Ensure the marks align properly. Turn the coarse filter clockwise until you hear a clicking sound. It is important that you fit the filters correctly.
Before calling service / Trouble shouting Before calling service check the following & Trouble shooting guide supplied on the following page. � ������������������������������������� �������������������������� ������������������������ ������������������������������ � ��� ���� ���������� ������� ������ ������������������������������� ������ ���� ������������ ��� ����� ���������� ���������������������������������� ���������������������������...
Page 25
Remove spots with silver polish. Rewash. Wash soon Prolonged contact with salty Pitting of after use, or pre-wash items if they will not be washed or highly acidic foods or stainless steel right away. Do not overload cutlery basket. Avoid with undissolved or highly items spilling or pouring detergent directly on flatware.
Page 26
Cooking Appliances, Washing separately from your retailer). Machines & Dishwashers. Important notes. Your new Beko product is guaranteed • Your Beko product is designed and against the cost of breakdown repairs built for domestic household use for twelve months from the date of the only.
Page 27
Beko Customer Help-Line. Tel: 0845 6004911 Model No: e-mail: service@beko.co.uk Serial No: Retailer: Beko plc, Beko House, Caxton Way, Date of purchase: Watford, Herts, WD18 8UF www.beko.co.uk For service under guarantee simply telephone the appropriate number below UK Mainland & Northern Ireland Fridges &...
Need help?
Do you have a question about the DSFN 1530 and is the answer not in the manual?
Questions and answers
programme does not arrive at the end of its cycle
The Beko DSFN 1530 dishwasher may not complete its cycle due to the following reasons:
1. The door is not fully closed, possibly due to a faulty door latch or misaligned door hinges.
2. Power issues such as an unplugged power cable or a blown fuse.
3. Water supply problems, like the water inlet tap being closed.
4. The machine was not turned on using the On/Off button.
Check each of these areas to identify and fix the issue.
This answer is automatically generated