Table of Contents
Advertisement
SECTION 1
9
10
11
12
13
14
15
16
9
10
11
12
13
14
15
16
19
20
21
ESSENTIAL PARTS
8
7
6
(Model 215)
17
7
6
8
(Model 207)
18
17
23
22
Name of Parts
1 Reverse stitch button
5
2 Pattern selector dial
3 Stitch length dial
4
4 Stitch width dial (for Model 215)
3
5 Bobbin winder stopper
2
6 Bobbin winder spindle
7 Spool pins
1
8 Bobbin winder thread guide
9 Thread guide
10
Thread take-up lever
5
11
Thread tension dial
12 Face plate
13
Presser Foot Pressure dial
3
14
Thread cutter
15
Presser foot holder
2
16 Needle plate
1
17 Extension table
18 Carrying handle
19 Handwheel
20 Power switch
21 Machine socket
24
22
Needle clamp screw
23
Free arm
24
Presser foot lifter
2
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the Huskystar 215 and is the answer not in the manual?
Questions and answers
I can’t get the thread to pick up the Bobbin thread and loop it up????
The Viking Huskystar 215 may not be picking up the bobbin thread due to the following possible reasons:
1. The needle is incorrectly inserted. Ensure the needle is properly installed.
2. The needle is bent or blunt. Replace the needle if it is damaged.
3. The bobbin thread is not threaded properly in the bobbin case. Re-thread the bobbin correctly.
4. Lint has collected in the bobbin case. Clean the bobbin case to remove any lint or debris.
5. The bobbin is damaged and doesn't turn smoothly. Replace the bobbin if it is defective.
6. The needle and/or threads are not suitable for the fabric or work being sewn. Use the correct needle and thread for your project.
Check and address these issues to resolve the problem.
This answer is automatically generated
Hand wheel is stuck
If the hand wheel on a Viking Huskystar 215 sewing machine is stuck, follow these steps:
1. Check if the machine is disengaged for bobbin winding – Ensure the hand wheel is properly engaged for sewing (refer to page 9 of the manual).
2. Inspect for thread caught in the hook assembly – Remove any tangled thread from the hook area (refer to page 32).
3. Clean the feed teeth – Lint buildup can cause resistance, so clean the feed dogs if necessary (refer to page 33).
4. Oil the machine – Lack of lubrication can cause stiffness, so apply oil as instructed in the manual (refer to page 34).
If the problem persists, further mechanical inspection may be needed.
This answer is automatically generated