Troubleshooting - DeLonghi ESAM 2200 Instructions For Use Manual

TROUBLESHOOTING

Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
PROBLEM
The coffee is not hot
The coffee is weak or
not creamy enough.
The coffee is delivered
too slowly or a drop at
a time.
Coffee does not come
out of one of the
spouts.
The frothed milk has
large bubbles
The milk is not frothed
Steam delivery stops
The appliance does not
come on.
POSSIBLE CAUSE
• The cups were not preheated.
• The infuser has cooled down because
2/3 minutes have elapsed since the last
coffee was made.
• The coffee is ground too coarsely.
• The coffee is unsuitable.
• The coffee is ground too finely.
• The spouts are blocked.
• The milk is not cold enough or is not
semi-skimmed.
• Cappuccino maker dirty.
• A safety device stops steam delivery
after 3 minutes.
• It is not plugged into the mains socket.
• The main switch is not turned on.
SOLUTION
• Warm the cups by rinsing them with hot
water (N.B. you can use the hot water
function).
• Before making coffee, heat the infuser by
pressing the
• Turn the grinding adjustment knob one
click anticlockwise towards "1" while the
coffee mill is in operation (fig. 7). The
effect is only visible after delivering 2
coffees (see the section: "Adjusting the
coffee mill" on page 11).
• Use pre-ground coffee for espresso
coffee makers.
• Turn the grinding adjustment knob
one click clockwise towards "7" while
the coffee mill is in operation (fig. 7).
Continue one click at a time until coffee
delivery is satisfactory. The effect is only
visible after delivering 2 coffees (see the
section: "Adjusting the coffee mill" on
page 11).
• Clean the spouts with a toothpick.
• You should ideally use skimmed or semi-
skimmed milk at refrigerator temperature
(about 5°C). If the result is not as you
wished, try changing brand of milk.
• Clean as described in the section
"Cleaning the cappuccino maker after
use"
• Wait, then activate the steam function
again.
• Plug into the mains socket.
• Place the main switch in the I position
(fig. 3).
19
button.