Table of Contents
Advertisement
Available languages
Available languages
Tire Pressure
WARNING!
maintained at all times. Never exceed the maximum
inflation pressure shown on the sidewall of the tire.
The recommended operating tire pressure is:
•
Approximately 10 psi for the rear tires
•
Approximately 14 psi for the front tires
IMPORTANT:
Refer to the tire sidewall for exact tire
manufacturer's recommended or maximum psi. Do not
overinflate. Uneven tire pressure could cause the cutting deck to
mow unevenly.
Gas and Oil Fill-up
The gasoline tank is located under the seat. Do not overfill.
WARNING!
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel machine indoors or
while the engine is hot or running. Extinguish
cigarettes, cigars, pipes, and other sources of ignition.
IMPORTANT: Your tractor is shipped with motor oil in the
engine. However, you MUST check the oil level before
operating. Be careful not to overfill.
Service and check the engine oil as instructed in the separate
Engine Owner's Manual packed with your tractor. Read the
instructions carefully.
IMPORTANT: It is important to NOT top off your fuel tank when
filling with fuel. Leave an expansion area available inside the fuel
tank to allow for the fuel to expand and for proper ventilation.
Otherwise the unit may not run properly. Fill the tank in
accordance with Figure 3-13.
14
14
S
3— A
ection
SSembly
Equal tire pressure should be
Use extreme care when handling
Figure 3-13
& S
-U
et
p
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the TB30 and is the answer not in the manual?
Questions and answers
CAN YOU PLEASE TELL ME WHICH BATTERY I BUY FOR the TroyBilt TB30 riding mower. Thanks for your help !
what size is the oil drain plug om a tb30r troy built mower.
The oil drain plug on a Troy-Bilt TB30R mower can be loosened using a 3/8-inch extension on a socket wrench.
This answer is automatically generated
I have been trying to assemble the steering wheel to the shaft, but it will not slide down to match up the retention holes. Is there something else I need to do? I have followed the instructions, but it will not match up. Figure 3 in the manual.
To properly assemble the steering wheel to the shaft on a Troy-Bilt TB30:
1. Use a 7/16" bolt (A4 20 bolt) to reduce play between the steering wheel and the shaft.
2. Place a washer on the backside of the bolt.
3. Secure the bolt with a lock nut.
4. Add a second nut on top of the lock nut to prevent loosening.
5. Tighten both nuts using two 7/16" wrenches.
6. Ensure the steering wheel moves the shaft directly with no play.
This setup ensures a tight connection between the steering wheel and the shaft.
This answer is automatically generated
On a troybult TB30R the throttle control doesn't engage throttle plate on carburetor all springs and linkages are connected and freely moving but thottle cable not engaging carburetor
The throttle cable may not be engaging the carburetor on a Troy-Bilt TB30R if it is not properly adjusted or seated. Even if springs and linkages are connected and moving freely, the cable itself might be loose, stretched, or misaligned, preventing it from moving the throttle lever on the carburetor effectively.
This answer is automatically generated
To remove the mower blade retaining nut, do I turn the wrench left of right looking from the cut grass opening ?