Connecting The Other Audio Component - Pioneer LX01BD Operating Instructions Manual

Connecting the other
06
audio component
Connect to the other audio component in order to enjoy the
surround sound of Dolby TrueHD, Dolby Digital Plus, Dolby Digital,
DTS-HD Master Audio, DTS-HD High Resolution Audio or DTS
Digital Surround. For instructions on connecting the TV and
speakers to the audio component, refer to the operating instructions
of audio component.
This connection is not necessary on this system. Use it to connect a
commercially available receiver to listen to 7.1-channel surround
sound.
Caution
• For DTS-HD Master Audio and DTS-HD High Resolution Audio
signals, the DTS Digital Surround signals are converted to linear
PCM for output (page 90).
Note
• Make the settings in the Setup Navigator menu according to the
type of cable connected (page 62).
• To output video signals from this player, connect using one of
the following (not including when connected using an HDMI
cable): a component video cable (commercially available), an S-
Video cable (commercially available) or a video cable
(commercially available).
When connecting to a 7.1-channel compatible AV receiver or
amplifier – Connect using 4 commercially available audio cables
(diagram below).
When connecting to a 5.1-channel compatible AV receiver or
amplifier – Connect using 3 commercially available audio cables
(do not connect to the surround back left and right terminals).
• After connecting, set Audio Output Mode to Multi-channel
(page 82).
94
En
Player's rear panel
FRONT SURROUND SURROUND BACK CENTER
L
R L
R
AUDIO OUT ( 2 ch ) AUDIO OUT ( 7.1 ch ) SUB WOOFER
OPTICAL
CONTROL DIGITAL
IN OUT
FRONT SURROUND SURROUND BACK CENTER
L
R
SUB WOOFER
AUDIO OUT ( 7.1 ch )
OPTICAL
CONTROL DIGITAL
IN OUT
To multi-channel
audio input
terminals
AV receiver or amplifier
Direction of
signal flow
VIDEO OUT
Y AC IN
VIDEO
P B
HDMI OUT
P R
COMPONENT
S-VIDEO
VIDEO
VIDEO OUT
Y
VIDEO
P
B
MI OUT
P
R
COMPONENT
S-VIDEO
VIDEO
To component video input
terminals