Part Names; Attaching The Nose Pad - Sharp AN-3DG30 Operation Manual

Using the 3D Glasses

Part Names

1 Infrared receiver
Receives an infrared signal sent from the TV.
The 3D Glasses turn off automatically after 10
minutes if no signal is received from the TV.
2 USB terminal
This terminal is for recharging and supplying
power.
3 3D/2D/OFF switch
This button switches between 2D, 3D and
OFF modes.
NOTE
• Do not soil or apply stickers or block the infrared receiver. Doing so may block signals from the TV and prevent the
3D Glasses from working correctly.
• Interference from other infrared communications equipment may prevent you from viewing 3D images correctly.

Attaching the Nose Pad

Attach either of the supplied nose pads as needed (such
as when the glasses do not fit properly). The glasses
come with a large and small nose pad.
Removing the nose pad
1
2
Attaching the nose pad
4 LED light
Power on: After lighting up in green for 2
seconds, the light starts slow blinking
(once every 3.0 seconds).
Battery power low: Blinks quickly in green
(once every 0.5 seconds).
Recharging: Lights up in red. When the
recharge is complete, the light turns off.
Power supply in progress: Lights up in
green.
5 Nose pad mount
The dedicated nose pad can be mounted
here.
Using the 3D Glasses
Turning the Power On/Off
Slide the switch to 2D or 3D to turn on the power.
Slide the switch to OFF to turn off the power.
• When the power is turn on, the LED light lights up
in green for 2 seconds and then starts slow blinking
(once every 3.0 seconds).
NOTE
• When the battery power is low, the LED light blinks
quickly in green after the power is turned on.
EN-5
3
5
4