Silvercrest SL 35 Operating Manual page 2

Overview of equipment
Front side of the receiver
Rear side of the receiver
Remote control
Overview of equipment
Front side of the receiver
1 – Infrared sensor for the signal of the remote control
2 LED STBY LED is illuminated if the receiver is in standby mode
3 LED ON LED is illuminated if the receiver is switched on
4 CH – Switches to the next lower channel location
Cursor moves down
5 CH + Switches to the next higher channel location
Cursor moves up
6 STANDBY Switches on and switches to the standby mode.
The default settings will be restored if you keep this key
pressed for more than 10 seconds.
Caution! By doing this, your personal settings will be
deleted.
Rear side of the receiver
1 LNB IN LNB connection for the antenna cable
2 IF OUT LNB connection for a second satellite receiver
3 VCR SCART connection for the video set
4 TV SCART connection for the TV set
5 100 – 240 V~ Mains connection
50/60 Hz, 20 W
6 ON/OFF Mains switch
7 RS 232 Serial port
8 COAXIAL Digital coaxial audio output
9 AUDIO L Left stereo audio connection
10 AUDIO R Right stereo audio connection
Guarantee
100% Black+Silver
for light surfaces
Sender please use block-writing in boxes with CAPITAL LETTERS
Surname
Firstname
Street
Zintek Systems Ltd
Zintek House
Postcode and city
Eurohaul Centre
Greenhills Road
Tallaght
Dublin 24
Telefon no. with areacode
Service-Hotline:
00353 (0) 1400 8353
Model / type: Sl 35 E-Mail:
info@zintek.tv
Signature of buyer
Faulty-Description: