Light - GE JSP26 Owner's Manual

Problem
Control signals after
entering cooking time
or delay start
Clock and timer
do not work
Oven light does
not work
Oven temperature
too hot or too cold
Oven will not work
Oven will not
self-clean
"Crackling" or
"popping" sound
Excessive smoking
Oven door will
not open after a
clean cycle
Oven not clean
after a clean cycle
Possible Causes
You forgot to enter
a bake temperature
or cleaning time.
A fuse in your home may
be blown or the circuit
breaker tripped.
Oven controls
improperly set.
Light bulb is loose
or defective.
Switch operating light
is broken.
Oven thermostat
needs adjustment.
A fuse in your home may
be blown or the circuit
breaker tripped.
Oven controls
improperly set.
Oven controls
improperly set.
This is the sound of the
metal heating and cooling
during both the cooking and
cleaning functions.
Excessive soil.
Oven too hot.
The oven temperature is
too high to set a self-clean
operation.
Oven controls not
properly set.
Oven was heavily soiled.
What To Do
• Press the BAKE pad and desired temperature or the
SELF CLEAN pad and desired clean time.
• Replace the fuse or reset the circuit breaker.
• See the Using the clock and timer section.
• Tighten or replace the bulb.
• Call for service.
• See the Adjust the oven thermostat—Do it yourself!
section.
• Replace the fuse or reset the circuit breaker.
• See the Using the oven section.
• See the Using the self-cleaning oven section.
• This is normal.
• Press the CLEAR/OFF pad. Open the windows to
rid the room of smoke. Wait until the LOCKED DOOR
light goes off. Wipe up the excess soil and reset the
clean cycle.
• Allow the oven to cool below locking temperature.
• All the range to cool to room temperature and
reset the controls.
• See the Using the self-cleaning oven section.
• Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
GEAppliances.com
27