Setting Remote Control Code Type; If You Forget Your Code Number - Pioneer DVH-P7000R Operation Manual

Initial Settings for
DVD player

Setting remote control code type

When the remote control operation switch is set
to , changing the remote control code type
DVD
enables you to operate the Pioneer DVD player
by the supplied remote control. There are three
remote codes, code type
code type .
DVH
When using this unit with a Multi-DVD Player
(e.g. XDV-P9 ), select code
II
When using this unit with a DVD Navigation
Unit, select code .
B
When using this unit only, select code
1 Set the remote control selection switch on
the left side of the remote control to the
appropriate position with a pen tip or other
pointed instrument .
• If you select mode, there is no need to
DVH
take the following procedure.
• If you select mode, take the following
A/B
procedure and change the code type to the
appropriate type.
2 Pressing and on the remote control
7 0
simultaneously changes the code type.
Initially, the code type is set to
Each time you press and
7
the remote control the code type changes
between and .
A B
, code type and
A B
.
A
.
DVH
.
A
simultaneously on
0

If you forget your code number

Refer to Changing the Level, step 3 on page 73,
and press 10 times.
CLEAR
The registered code number is canceled, letting
you register a new one.
Section
10
En 77