Advertisement
F E AT U R E S - O P E R AT I O N
COMFORT GEL INSERT
The Comfort Gel Insert has been included for your luxu-
ry and comfort. The soft gel sole contours to your feet
providing soothing warmth and relaxation for your tired
feet. You may also choose to use your Comfort Gel Insert
without warming. A chilled Comfort Gel Insert is a
refreshing way to invigorate your feet. Whether warmed,
at room temp, or chilled, the Comfort Gel Insert helps to
soothe aches and rejuvenate your weary feet.
TO USE:
1. TO WARM the Comfort Gel Insert, fill a tall pitche
with HOT TAP WATER. Then place the Comfort
Gel Insert into the hot water and let sit for approxi-
mately 5 minutes or to your preference.
2. Use caution not to scald hands when removing
Comfort Gel Insert from hot water. First, pour out the
hot water and then remove the Comfort Gel and place
in Foot Spa. You may also opt to use your gel pack at
room-temp and therefore no heating is necessary.
CAUTION:
•
Only use tap water when warming Comfort
Gel Insert
•
Do not place Comfort Gel Insert into boiling
water
•
Do not microwave Comfort Gel Insert
3. TO CHILL the Comfort Gel Insert, PLACE IN
FREEZER (for up to 2 hours) or in
REFRIDGERATOR (for 2-8 hours.) Once gel
has cooled to your preference, remove from
cooling source.
4. Place Comfort Gel Insert onto the floor of the
Foot Spa.
5. Ensure that the unit is unplugged before filling
with water.
6. CAUTION: Do not fill past Fill line.
Do not use on surfaces that could be damaged
by water.
7. Once the tap water has reached the temperature of
your preference, fill the Foot Spa with clean tap
water to the designated water level. Overfilling the
tub may cause splashing. If you do not want warm
water, fill with cool water.
THE HEAT FUNCTION ON THIS FOOT SPA
WILL MAINTAIN WARM WATER TEMPERA-
TURE. IT WILL NOT HEAT COLD WATER. FOR
BEST RESULTS FILL WITH WARM WATER.
8. CAUTION: Use caution when carrying unit. Unit
can be heavy with water inside.
9. Place Foot Spa on a dry, level surface that will not
be damaged by water should any splashing occur
Always be sure that hands are dry before touching
power cord or control dial.
10.Plug the power cord into a household
120-volt outlet.
11.Set the control dial to the setting of your choice.
The four settings are:
A. OFF (No massage)
B. VIBRATION, HEAT
C. WATERFALL & HEAT
D. WATERFALL VIBRATION, & HEAT
•
The Comfort Gel Insert may be used with each of
the above settings, if desired.
C
B
A
VIBRATION:
Sends wave after wave of rejuvenating massage
to feet.
HEAT:
Helps to maintain warm water temperature.
WATERFALL:
Cascade of water.
COMFORT GEL INSERT:
Cushions and helps relax tired feet in
luxurious comfort.
DO NOT stand on or in appliance.
Use only while seated.
D
Advertisement
